Wireless

I have a customer who would like to connect a warehouse (located across the street/approximately 150 feet closet to closet) to its main network. The existing warehouse has a 3548 switch which I would like the new warehouse's 2950 to connect to. I hav...

I wish to ask if the 802.11a products are in market or not yet, cause I contacted a distributor for Cisco, and he told me that it will be available in the coming years!!! I want to make sure that this is right. I know about the 802.11b, but I'm inter...

If we have a max distance of 10Km, for a directional it would surely mean between devices. For an omni, does it mean between devices or that includes the diameter of each omni devices?

Our University has recieved funding to do a Campus Wide site survey to implement 802.11a wireless lan. Two questions. 1)How will we be able to do an acurate 802.11a site survey without the Cisco equipment being released? 2)Is Cisco slow to release 80...

i want to ask if there are some wlan cards that runs in freequencies from 10 to 15Ghz of if its possible to change the frequencies of wlan cards

I was asked to 'fix' a BR500 implementation with poor signal strength.I need to improve the System Operating Margin by adding gain to the receive side, but the manual does not show dual connectors (like the 340/350), so I can't do it unless the card ...

Hi, Im starting a Wireless ISP in my area. The main office sits about 1000' about ground level with 3 large cellsites within 5 Miles of eachother. The idea is to use 5.8Ghz Dish Antennas to push 50MB from the Office to each cellsite. Then I'd like to...

Hi,I'm trying to install a Aironet PCI352 PCI adapter card in a Compaq Deskpro 4000-5166 MMX (166Mhz) running Windows 2000. It detects the card ok and installs drivers, but when I try to reboot, it crashes before I can get into BIOS settings. It seem...

Hi,Still dealing with the filter configuration on AP350.Filters can be designed based on the ETHERTYPE, IP protocol and IP port. Focusing on ETHERTYPE filters, how can I filter out 802.3, 802.2 frames ?Thanks and best regards,Guy

Hi there,I am trying to determine the best products to improve the strength of a wireless network I manage. This network is located primarily in a 5000 square foot building. I use a 340 series AP and 340/350 series PCI and PCMCIA cards. Performance i...

I am setting up a link of around 13 miles but I won't be able to match antenna height at both locations. The root system's antenna is at a hundred and twenty feet and the client node's antenna is at 75 feet. I would like to know if there is a place I...

Has anyone out there managed to get Hot Standby working on a secured WLAN with LEAP? I cannot manage to get my clients to do anything more than roam to a different AP with LEAP. When I enable the standby on the second AP and take down the Ethernet on...

himy cisco br342 bridge firmware is 8.24v. i wanna upgrade it to 8.65 or higher. how do i this?would you please tell me that what kind of Firmwares is best for me.i have two aironet342 Bridge, and have 4Km distance from eachother.and i have 2 Andrew ...

I've been having a recurring, intermittant problem with DHCP-assigned IP addresses not getting assigned to Aironet 350 equipped Compaq iPAQ PDAs. I've upgraded the card (4.25.23) & AP (11.10T) firmware to the latest versions. iPAQ client software is ...

Does anybody know if the Compaq iPAQ PPC2002 supports Cisco's Aironet 350? I see drivers on Cisco's website for Windows CE 1 - 3 but nothing for PPC2002.Ben