Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Welcome to the Cisco Community Ask Me Anything Event   Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...

Shree Hari AB.jpeg Screenshot 2026-09-11 at 3.12.04 PM.png

Hi all,anyone have any experience with trouble dialing into a cisco 3640??we have currently just bought a siemens laptop that will not dial into the router with error message 678 "no answer" - however we have other laptops that dial in fine and they ...

redmayne by Community Member
  • 1078 Views
  • 1 replies
  • 0 Helpful votes

AllNeed help!I have a client that needs Symbol Netvision integration with CCM 3.0(9).I hv tried to look thru the CCO but no concrete solution .Do anyone in the forum can help me in this integration.What should I configure in CCM and the gateway.I am ...

uttaran by Community Member
  • 1118 Views
  • 1 replies
  • 0 Helpful votes

Are there any good configuration examples for a large mobile ip network?

felecia by Community Member
  • 1404 Views
  • 2 replies
  • 0 Helpful votes

I have tested the ACU utility for the Access Point 340 cisco, works ok with the PCMcia card, the LSM (Link Status Meter) works fine.I need the same tool for test the link between two aironet Cisco Bridges 340. Can tell me please if that tool exist?.t...

evolutionet by Community Member
  • 1268 Views
  • 2 replies
  • 0 Helpful votes

I have 3 locations A, B, and C. Out of which A is my Server location and does not have LOS with C. While B has LOS with both A and C. How can I use 350 bridges to overcome the problem at location B ?

1.When the bridge AIR - BR352 (350 series) will be on sale?2.Is it possible to know previously its cost (approximately)?In GPL its cost is not specified. Thanks in advance for any replay.

asvir by Community Member
  • 979 Views
  • 1 replies
  • 0 Helpful votes

I have a customer looking to deploy a WLAN. His users are distributed over 3 VLANs. He would like to have his users be able to roam throughout the WLAN, and still retain their VLAN assignments.We thought we could do this via dynamic VLAN ports, but s...

Just trying to see what kinds of ditances people are using these links at, as well as how high they have placed their antennas in order to achieve that distance? I think a small discrition of the equipment used would be helpful as well. We could use ...

jcomca by Community Member
  • 1979 Views
  • 4 replies
  • 0 Helpful votes

Hello,I am running BGP on my Cisco7204 router. I have a network of 8292 nodes. the gateway for all my nodes is the router mentioned above. I connect to an ISP with another AS. I too have an AS number. I want the request send by nodes in my network as...

Gentles all,I am planning to connect a lecture hall in a university with wireless devices. The lecture hall will seat approximately 400 people (ostensibly all will have laptops). I have been told that the average wireless LAN device can only support ...

bsalahor by Community Member
  • 1643 Views
  • 3 replies
  • 0 Helpful votes

Hi, I am tring to understand what type of link I will get with WT2710 at one end and WT2755 at the other end. I can read that it provides 22.2Mbps down and 18Mbps up. Then it describes it has a shared bandwidth downstream and that it uses frequency d...

Review Cisco Networking for a $25 gift card