Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from  Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...

Sai.png Prash.png

Hi, I have tried to reset AP1852I using mode button and also using command "capwap ap erase all". But the AP is not fully restored. I can still see these files in the flash drive: AP34F8.E710.5018#show flashDirectory of /storage/total 36-rw-r--r-- 1 ...

Dear Cisco CommunityI am having Trouble, joining a Cisco MAP (9124AXI) to a Cisco 9800-L WLC through a Cisco RAP (also 9124AXI). In the Web-Interface of the WLC (Monitoring -> AP Statistics -> myRAP -> Mesh -> Neighbor) I can see the RAP recognizes t...

Cisco Case neighbor ap.png

Hello All,I am wondering if anyone has any ideas or If I am just missing something obvious.As an organisation, we collaborate with a lot of other organisations and we have a few of the organisations SSID's Anchored to us. Most organisations we collab...

jama by Frequent Visitor
  • 1643 Views
  • 2 replies
  • 0 Helpful votes

If you have a choice between the two, which one will you choose?We got our budget approved for Cisco ISE but at the same time, it looks like we can do the same with ClearPass for a lower cost (and we can use the extra money for other stuff). Is the I...

Marc_Abaya by Level 3
  • 11531 Views
  • 11 replies
  • 0 Helpful votes

Hi,We have a wireless mesh network in our mine site and we're using Aironet 1562 access points. All of our equipments (clients) are 2.4 ghz, so we're not utilizing 5 ghz channel for any clients. In two of our access points, which is attached on a tra...

serkanatasoy by Community Member
  • 1191 Views
  • 1 replies
  • 0 Helpful votes

I have multiple SSIDs that share a common vlan interface to the outside that require SSID specific restrictions.  In AirOS, the ACL's are applied to the SSID/wlan in the advanced/interface overide ACL spot.  But I don't find such feature in IOSxe (17...

We are preparing to change the channel width from 40 mhz to 20 on our Cisco WLC.  Once this change is made, what kind of impact can we expect for the client devices? Also, we are adjusting the Data rates, removing mandatory for some of the lower rate...

echoknight by Community Member
  • 2097 Views
  • 4 replies
  • 0 Helpful votes

Can the 9120AXE support workgroup bridge mode and act as a wireless client (and if so how do I configure it)? I'd like to use it as a test client to validate 4x4 performance of my wireless network and ideally would be able to associate to any AP as w...

josh1111 by Community Member
  • 6644 Views
  • 5 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card