Forum Posts
Hi chaps,I'm trying to recover a C9130 which failed to upgrade the code and now is in a loop boot, but it seems to me that the recovery process from U-Boot couldn't be the same as C9120 from this guide as C9130 is unable to ping gateway, any ideas?Re...
Really struggling here and managed to lock myself out of my WLC. I have setup the radius device IP and network policy using service type as administrative. NPS works for access my switches and routers so I know its working. I moved radius to the top ...
Hello Team,we are using flex connect mode of access point, in which the data traffic switching locally and central authentication.here i have doubt, whether the user authentication traffic (control traffic) how it will reach controller.user>> cawaptu...
Set up SSID with WP2-AES on the 5GHz N and AC and can't see the AC beacon. With just AC radio on nothing shows in WiFi scan. When I turn on the N radio I see the SSID identified as N450. I can detect other SSID's that are AC1300 around me so why can'...
On one of our MR42 access points we have added an SSID that is separate from the one we use for the rest of our MR42 access points spread throughout the locale. Things has been working fine until about a month ago where the users of that SSID started...
Users reporting connection blips throughout the day. Device reconnects, but causes a disconnect on zoom, etc.Hard wired unaffectedAbout 20 MR46 running MR28.6 firmware running basic indoor profileLogs show lots of Authentication failures with "EAPoL ...
Trying to set up Mobility tunnel between 5508[Anchor] - 9800 [Foreign] 5508 is already on the IRCM supported version as follows AIR-CT5500-K9-8-5-182-104.aes, I can't see any option under GUI/CLI for security mobility, as i understood on 9800 it wil...
I want iOS image for downgrading Cisco Aironet 3700 series controller based router(AIR-CAP3702E-x-K9) to a standalone AP. I looked at http://software.cisco.com/download/navigator.html?mdfid=285024921&i=rm path, but unfortunately i couln't find the im...
AP disconnect automatically and join again Showing trap disassociated previously due to ap crash ap mode 3800 why this problem face and how to resolve? please help me
[*12/14/2022 06:23:05.5811] waiting for WCP to initialize[57C[*12/14/2022 06:23:05.5811] waiting for WCP to initialize[57C[*12/14/2022 06:23:05.5811] waiting for WCP to initialize[57C[*12/14/2022 06:23:05.5811] waiting for WCP to initialize[57C[*...
Hello,I have a Cisco WAP571 AP with 2.4 Ghz band enabled, in 802.11b/g mode. Since a week ago, all clientes connected to it disassociate after some minutes and have to connect them again. It is located in a closed building with only one floor and no ...
Hello Experts,We have a client who is managing a community of villas and Apartments ( around 300 villas and 500 apartments) and its a big site including Outdoor areas.They have asked our suggestions to design WiFi and one of them seems very strange r...
Running 17.6.4 on 9800-402.7.0.356 patch 6 on ISEWhen I run "password encryption aes" on the WLC,ISE will not accept clients for DOT1x authentication. works fine before running the command. and after a "no password encryption aes" and reboot it works...
Hi all, I configured a WLAN on our Catalyst 9800 controller with MPSK. It works fine and can connect with one of the preshared keys. However, how do I know which key does the client uses? I don't need to see the entitry preshared key, only the priori...
