XR OS and Platforms

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Take

 

Forum Posts

We setup a new ASR 9010 and have 2 9000v shelfs that we want to use just as access switches.  We connected both 9000v's each with a LAG uplink.  Both shelves show they're online and ready.  Question 1-  what's the purpose of the "satellite remote por...

I'm facing an issue while attempting to configure IPv6 ABF on a Trident (A9K-8T-L) Line Card for the ASR9K platform. When attempting to commit, I receive the error:interface Bundle-Ether200 ipv6 access-group ipv6-ingress ingress interface-statistics...

Lyphiard by Level 1
  • 545 Views
  • 1 replies
  • 0 Helpful votes

I am looking for a concise configuration for "policy based routing" on the NCS 5000 series running 6.3.3. I have looked in the configuration guides but I cannot find anything. The ACL Based forward I have read about id not featured in 6.3.3. When I c...

fernster by Level 1
  • 1219 Views
  • 3 replies
  • 0 Helpful votes

Resolved! Management Plane

Hey Guys,   I can't figure out if what I am seeing is expected or if it is a bug.   So I have a 9001 running on 6.4.2. The router has a few external connection links. I would like to have one loopback interface as inband management interface so I hav...

Aruba_Net by Level 1
  • 1874 Views
  • 4 replies
  • 0 Helpful votes

Hi All,   I want to know, by default how many paths would ospf consider for ECMP in ASR9912 or IOS-XR platforms and how many maximum paths it can take for ECMP?  I have checked the device and it gives an option to go upto 64 but some of the documents...

I'm facing a peculiar error where a TenGigE interface begins rapidly flapping continuously until it is shut/no-shut through the command line. This particular interface is part of a 2-port LAG doing MC-LAG with a set of Juniper switches.   RP/0/RSP0/C...

Lyphiard by Level 1
  • 2216 Views
  • 4 replies
  • 0 Helpful votes

I'm using Cisco ASR 9001 router,  the router is not saving configurations.  see below sample configuration. please how can i fix this   RP/0/RSP0/CPU0:LLC-IGW(config-if)#int gig0/0/1/19RP/0/RSP0/CPU0:LLC-IGW(config-if)#no ipv4 addressRP/0/RSP0/CPU0:L...