Buy or Renew
Buy or Renew
Meraki Community is live! Welcome Meraki Members! Learn more here.
Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
2250219members
2695817discussions

Featured Content

Trending Topics

Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!

Community Activity

Start a conversation

Cisco switch

Hello everyone i see logs on the switch.%SYS-2-MALLOCFAIL: Memory allocation of 395648 bytes failed from 0x1AE504, alignment%Error on initialize VLAN database 1: VTP feature not yet initialized[OK]googled this issue, found memory is low, how to solv ...

Mlex1 by • Spotlight
  • 464 Views
  • 8 replies
  • 0 Helpful votes

CoPP ACL

Hello everyone i want to make ACL for CoPP but i have a doubt witch have to make it.ip access-list extended ACL-CoPP-IPsecpermit udp any eq isakmp any eq isakmppermit udp any any eq non500-isakmppermit udp any eq non500-isakmp anyorip access-list ext...

Mlex1 by • Spotlight
  • 188 Views
  • 4 replies
  • 0 Helpful votes

SDWAN Viptela NAT

I am working on a NAT configuration for a SDWAN Viptela install similar to below ip nat pool 123interface natpool1ip address 10.123.123.0 /24natstatic source-ip 10.123.200.30 translate-ip 10.123.123.30  outsidethis is a working installation the route...

XRv9K messages and problems

My XRv9K 7.2.1 nodes in EVE-NG are unstable.  Occassionally the interfaces are removed completely.  Sometimes the nodes reboot.  I see these messages. 0/RP0/ADMIN0:Nov 3 03:05:04.214 UTC: vm_manager[2832]: %INFRA-VM_MANAGER-4-INFO : Info: vm_manager ...

a-gould by • Level 3
  • 5174 Views
  • 11 replies
  • 0 Helpful votes

need help cli template - banner motd

 Hello everyone,I have a strange phenomenon which is probably just a minor issue.I am using the following configuration in the CLI template:  !banner motd ^C***************************************************** !!Device is managed by DNA-Center!! ...

Flapping Issue in Cisco Switch

Hello,I got a log from switch."%SW_MATM-4-MACFLAP_NOTIF: Host b6f4.10ae.25dc in vlan 50 is flapping between port 1 and port 2"Can anyone tell me why I'm getting this and what should I do now?

Ehsan97 by • Community Member
  • 220 Views
  • 7 replies
  • 0 Helpful votes

SSE Licenses

Hello everyone, I just want to clarify the licensing of Secure Access. Is it per user or per device? If per user, how many devices are supported at the same time of using, for example, zta or vpn or umbrella agent? I noticed as well in the trial that...

Resolved! Cisco 9350-HX Stacking query

Hello All,I have a query if I may.We have recently procured few 9350-hx switches. We have several 9300-48u and 9300-uxm in production. We tried stacking the new 9350s as we have 9300s stacked. But it would not work as in the stack members wont show c...

SheikhIslam_0-1777982282628.png SheikhIslam_1-1777982628922.png

Resetting an Aironet 1852i

Hi, I have a recently-installed Aironet 1852i (AIR-AP1852I-E-K9) which was working fine until yesterday, when I found it wasn't transmitting. I couldn't communicate with it over the wired network. It wouldn't respond to pings. CDP from the adjacent s...

Load more