The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Dear Community Members., I have a 2901 router that need to push about 500mb Data traffic via Its Gigabits Port.Do I need a License and how can i get one to be able to achieve this/
The system was getting APIPA ip add. After logging in to the switch we fonud the following output : -Vlan Mac Address Type Ports---- ----------- -------- -----20 7085.c281.66bd DYNAMIC Gi1/0/3430 bd7085.c281.66 DYNAMIC Te1/1/1We checked the dhcp logs...
hi,i would like to express my issue and if you are able to advice me . i have a company router IR1101 with internet connection provided with private ipv4 address in the WAN interface. my company uses DMVPN in order to connect to company infrastructu...
Good day, Our work is using some 2960x and 3850 as Layer2 and Layer 3 switches. As there are some vulnerabilities in the old firmware we are checking in upgrading it to the latest release however by upgrading it, it will move to smart licensing. What...
Hi,We have a cisco 4221 router. When I try accessing its GUI page on https://192.168.10.1 its not letting me access that.What all I have tried and not working is as follows:Tried older version of firefox which supports TLS 1Tried fiddling with the fi...
Hello, Could anyone please give me a rough idea of what is possible with Cisco Catalyst Centre regarding the Day 0 Install of 9200L Switches that will be stacked? What benefits can Catalyst Centre bring to the immediate install of the switches such a...
Hello. I always get useful information from community. Can I configure "bandwidth" command for cEdge router via template ? Ex) Interface GigabitEthernet1 bandwidth 5000 # Possible to config this through device/feature templa...
Hello experts, We are considering deploying N+1 WLC in a regional basis. The requirement is to have a backup WLC in the regional site in case the local WLC presents a failure or is unreachable for long periods of time. My question is if such an AP co...
Co-Author: @Qi Li This guide will explain the migration method from the open source container NID towards the Cisco Containerized NSO instance. To be more specific, the migration is towards the recommended Containerized NSO framework with best pract...
Hello,I am currently facing a recurring issue with the configuration of an IPSec VPN between a Cisco router and a Bintec router. Although the VPN tunnel appears to be functioning correctly and is displayed as "UP-Active" on both sides, no traffic is ...
I would like to understand how the vulnerability reporting works in SNTC. Lately, I have been noticing something strange. Not sure, if it is a reporting issue or something that I am missing. For instance, the SNTC is reporting the following vulnerabi...
Hi.When I'm trying to claim a new target from my Sandbox in Intersight I get the message:"The device has not been updated to support claim in this region. Please wait for device to be upgraded, if issue persists please contact Cisco TAC.". How can I ...
Hi Expert,Recently, one port on our 9200 switch went to err-disable state and the status LEDs are all off. The port configuration is as below: it is connected to a desktop PCThe logs is as below, it looks before it goes to err-disable state, the port...