Application Networking

I have two CSS and configured to use Active-Backup stateful failover.I also have several WWW and SSL servers.I found that the client cannot get back to same server after failover.I guess the problem is the stricky information is not replicate from ma...

Hi,If a content engine is configured for both incoming and outgoing proxy, why does it need to do DNS lookups prior to forwarding packets to the outgoing proxy?From traces taken, this can add 1 to 2 seconds of delay to the web page being displayed....

I have the need to use different default-routes depending on the source-address of the packet, when it comes from the content switch (e.g. from a group-address or as response-packet in a conversation witha content address).The reason for this require...

I am running the ap-kal-smtp script against an SMTP gateway. Everything is working fine. But I would like to change the frequency to 5 mins. instead of 5 secs. When I increased the frequency parameter to 255 the service goes into dying status. I a...

I'm using this command in order have to have VIP source ip address. However, I am confused with the "add service" and "add destination service" under this group command. Reading the documentation adds to the confusion. How do we use these commands...

Hi,I have a small query I have 2 11503 Content service switches CSS-1 & 2 . i want to make both CSS Active & i have servers below it each serves are having 2 NIC card one connected to CSS-1 & other NIC connected to CSS-2 just for redundancy . I want...

I have 2 web servers, 172.16.10.80 & .81, and a CSS11154 connected to a Cat2950. The CSS's VIP address for the web servers is 172.16.10.95. My problem is no device within or outside this segment can access the web servers utilizing the VIP address....

Current Hardware: CDM-4630 and CE-560 running ACNS 5.1.9.5, all servers and ACNS hardware on local LAN. I have a single channel setup and a crawler manifest to fetch about 2gig of Windows Media ASF files. The crawler is using HTTP and I'm not allowin...

What is the default username and password for the CE module installed in a 2600 router. I searched all the documents and cannot find the default info to start configuring.Seth

3750-switch is running ver 12.1(19)ea1cCSS-11500 is running 7.10 build 102The GE1 interface in running normal and I ping to/from the switch and CSS, the 3750swi fiber Gig port is solid green.. everything o.k.But the GE2 from the 11500 css causes the ...

Has anyone compared IOS based webserver balancing to Alteon boxes ? 1) What are the benefits of 6509 MSFC based SLB vs ALteon (if any !) 2) Is there any bugs,or performance problems on IOS based SLB? 3) Is there any particular setup for Webspheres r...

Hi,We are running a CE565 with Application and Content Networking System Software Release 5.0.3 (build b5 Apr 30 2003) software release. It is configured to run as a "proxy-style" cache.The problem I have is that when we try and access a FTP site via...

Simple question. Can I run SSL through the CSS without the use of the SSL Module?Thanks,

I had configued a serverfarm with 2 real servers,and also configured a vserver for it.It seems service and server state are all right.But when I chech real server details by issuing " sho ip slb real detals".I found that "total conn failures" keeps i...

I didn't know the command filed of show ip slb real deails : 192.168.2.10, WEBFARM, state = OPERATIONAL conns = 114, maxconns = 4294967295, minconns = 0 weight = 8, weight(admin) = 8, metric = 14, remainder = 2 total conns established = 264898, to...