Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a CSS 11503 that we use to balance SIP calls(UDP) among our SIP servers.We have a content rule that balances the incoming traffic and a source group to NAT the outbound traffic. Both the content rule and the source group use the same IP addres...
How to include ? sign in webhost redirection string in cisco ACE ? i tried using [] and \ as per cisco doc but it is not working.Can anyone help? How to use [] and \ to include ? symbol
I have trouble with ACE 4710, The SLB work but I see very much bad tcp chsum. 17:30:41.308878 00:0b:fc:fe:1b:01 > 00:23:ea:89:68:44, ethertype 802.1Q (0x8100), length 64: vlan 30, p 0, ethertype IPv4, IP (tos 0x0...
I'm trying to setup an ACE 5.2(1) configuration so that clients from Subnets A-M get NATed to one address, and clients from subnets N-Z get NATed to another address. (This way the proxies in the serverfarm which are being balanced can request authent...
Hey there,i tried to install more RAM into a 294 with 4GB installed.I replaced the two 2GB bars with two 4GB bars of same type but system is not starting anymore.Switching back to 4GB and all is okay.The system stops at "BIOS post ongoing...".Upgradi...
When I run the show service-policy I can find info about dropped connectios, but What is the cause of a "dropped connection" ?Server? LAN? LoadBalancer?What is understood for a "dropped connection"?Dropped connection is not the same tha a timeout see...
I had a simple scenario: 2 servers farms (each with two rservers) one for HTTP and another for FTP. Two VIPsEverything works fine, but when I try to access from one Rserver from the HTTP to the FTP-VIP nothing happendHow can I resolve the traffic bet...
Hi,We are operating the ace(csm) and using the sticky option.Assuming that We have two servers with sicky for redundancy and being opreated active - active, I realized that if one server go down and go up, Csm dosen't forword packet to restored serv...
I'm trying to get a MAC <=> IP mapping from a Cisco ACE. Unfortunately according to this table, while it supports IP-MIB the ipNetToMediaTable and ipNetToPhysicalTable subtrees are not supported. Is there any other way to get this information, may...
Hi,I have the need of a dual probe with a AND-action, ie both probes needs to be down to take the service down.The following configuration is an OR-operation but I need a AND-operation.Any? Scripted?probe https HEALTHCHECK-OPEN-SSL interval 10 pass...
Hi,I have certificate in PEM format (.cer) and private key file in .txt format.When i use openssl to create PKCS12 file from above files, it gives me error loading private key file. It requires file in .key format instead of .txt format.Do we have a...
I have a scenario where there are 3 WAE devices used in a site. We are using MASK of 0x3F (6 bits) on source IP address for distribution to achieve as fair a bucket distribution to the devices as possible - 21 buckets, 21 buckets and 22 buckets. I un...
Hello,I have applied a sysLocation variable to a large number of WAAS/WAE 474's using snmp [oid .1.3.6.1.2.1.1.6.0]Is there a vendor specific MIB to perform a wr mem without logging on to each box ?I have tried the OLD-CISCO-SYS-MIB variable .1.3.6.1...
