Hi community Recently we implemented a POC with Fabric using the topology below. Activities carried out are:- Integration with ISE (16 SGTS)- Fabric topology (SW 3850 "CP-B", 2 SW 3560 "Fabric")- Global configuration DNA has the IP DHCP Server.-The V...
Hi I am new to DNA and I try to understand how DNA to work. When i search online, I got a lot documents. Some of them explain very detail, but what I want is to find document which is short and briefly explain how it work. Anyone can send document li...
Hi All,In my fabric network Trustsec policies are not working in inter-VN traffic. I investigated and figured out that traffic from Border to Fusion passes without tagged. As I understood after Border decapsulates VXLAN it does not add CMD SGT Values...
Hi, I want to intall DNA center ( Standalone Mode) and migration the current huge Infrastructure ( about 9 big site), Data center (HQ), and some sites reacheable via VPN link ( WAN). So, i will only use the DNA as a single point of configuration ( ...
How device configuration can be exported unsanitized so that it can be reused with all credentials e.g. manuel RMA of a device?Any way to switch between unsanitized / sanitized mode for the CLI output in DNAC ?
Hi,We have bunch for 2960x as Edge and 4507-R as Core switches, so is it possible to use DNAC for LAN automation and assurance ?What other benefits we can accomplish from DNA without SD-ACCESS ?Any suggestions ?
hello, my question is : what is the procedure to replace a border node in case of hardware failure? this question since part of the configuration is manual ( ibgp between border) and another is provisionned ("lan automation, ...) thanks
I'm using DNAC 1.3.1 do the assurance with WLC (3504 - OS version 8.8.125)+ AP (2800). I configure WLC and AP with Flexconnect + Local switching mode, and under flexconnect group , it automatically enable AVC for all WLAN ssid. I check on WLC (Monit...
Hello,I have a question about the trunk connection between border and fusion router . when provisionning overlay network , DNAC implement vlan range start to 300X for the connection vlan/vrf of the VN . this is mandatory or you can change this range...
hi guyshow can i have a report on cisco prime 3.5 to see how many watts is remain on my switches ?thanks.
Hi, We have a client who is looking to deploy DNA Center plus SD-WAN with Advanced Security in their network. The C1111X-8P-DNA-PM suits their needs however this product is approaching the end-of-sale date. The 1100 series datasheet notes: "The Cisco...
We are thinking about to connect all Cluster ports to one LAN switch. As stated in HA guide 1.3.1.0 an appliance port / Cluster Port failure can be recovered by the cluster. What will happen in our case, when the LAN switch will fail and all cluster...
We are designing a SDA setup with 9300 as edge nodes.and 9500 as border node. My question in regards to DNA licensing:- Do we need to buy DNA premier and separate license for ISE appliance ?- We tried to generate BoM using Cisco CCW portal and it in...
Is the Management port on the DNAC required/recommended for deployment or would the Enterprise port suffice especially in regards to accessing the DNAC GUI? What is best practice? Any downside not using the Management Port on the DNAC?
Hey All,I really need to explicitly understand how each kind of traffic (Intra VN, Inter VN, Outside traffic and etc) flows in Fabric network. I want to know what LISP requests are made, how next-hop is determined, how route determined and etc. Could...
