Cisco Software Discussions

Hi all, I have request from customer who is currently using CUCM version 10.5. I would like to integrate the customer's CUCM into a contact center solution via JTAPI.For development and testing I need a CUCM version 10.5 license. Is there a possibili...

Hello All, Could you please help me to guide for installing sm-x-40g8m2x in ISR 4331 router?   

sg350 switch reboots when uplink is plugged in.it not only reboots but it restores to default factory settings.Tried by disabling STP.please help firmware 2.4.0.94  

I think I must have inadvertantly changed a setting? maybe?When I record, it says I'm recording fine and saving on my desktop.When I go to look for my recording, I can't open it.When I look on My Recordings, it used to show up there, no problem, but ...

Hi can anyone  able to solve this issue what is was facing this error was new to me,but if I copy that cmd and execute means its working properly in asa cli  andalso check for asa asdm updates not working properly ASA-5505ASA ver-8.4(2)ASDM ver-7.3(1...

How do I obtain an image for these. looking for c1140-k9w7-tar.124-21a.JY.tar to convert from light

I have upgraded the CAT environment C3850 (standalone) and the Production Backup Data Center C3850 (stack) from 16.3.6 to 16.9.4 without issues. We have later decided not to proceed with Cisco Smart Licensing and wanted to downgrade to 16.6.8. We tri...

Hello, It's the first Nexus family switch im going to upgrade. Currently I've this type of model:   show module Mod Ports Module-Type Model Status --- ----- ----------------------------------- ---------------------- ------------ 1 48 Nexus 5672UP Sup...

I’m trying to upgrade my Cisco 7962 & 7965 phone firmware that I just got but I’m having some issues doing it. I setup everything right in the TFTP64 server that I got from watching a video, but when I connect my laptop to either phone, thanks to my ...

I am trying to set up a test for my class, where the students are free to enter any IP-Address for the Default Gateway within the subnet range.I created a Number-Pool ranging from 1-254 and asigned it to the variable [[Oct4]] ("Entire Range").I then ...

Hi, I suspect my terminal servers are no longer supported but I'm hoping to try to recover one that cannot remember it's config. The problem was detected when our lab was taken offline and physically moved across town. The solution I was going to try...

Hello,   I am using Cisco Unified Call Studio version 11.6, I don't see class folder of com.cisco.cvp.vxml.custelem in my installation folder, can anyone guide me where to find it?Thanks.