Data Center Switches

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Save 25% on Day-2 Operations Add-On License

 

Forum Posts

Hi All,I faced a very strange issue and I am trying to dig down the exact cause for this. I had deployed new servers and connected them to a stack of 3850s. I tried creating a port-channel and the limitations of server prohibited me from doing so. I ...

I have two of the same routes in my routing table, one is OSPF and one is eBGP. I want the OSPF route to be preferred over the BGP route. (The eBGP route will be the backup route when the OSPF route is gone)I configured a BGP route map to apply a hig...

velo84 by Level 1
  • 680 Views
  • 0 replies
  • 0 Helpful votes

Nexus SW:-  NXOS: version 7.0(3)I7(6)This SW has BGP peering with Cloud Vendor 1 , Cloud vendor 2 , Cloud Vendor 3 requirement is :-I would like to advertise routes originated from cloud vendor 1 to cloud vendor 2 and ignore cloud vendor 3 and other ...

NDP by Level 1
  • 718 Views
  • 0 replies
  • 0 Helpful votes

I have two Nexus 9000s configured as VPC. I have an ASA firewall with a VPC port-channel to the Nexus switches. I am peering OSPF between the Nexus and the ASA. Both of the Nexus and the ASA are in Area 0. I want to block some routes being installed ...

velo84 by Level 1
  • 885 Views
  • 0 replies
  • 0 Helpful votes

Posted to Data Centre blogs by mistake, reposting here. I'm having a strange problem redistributing iBGP routes to OSPF on Nexus 9000. Initially I had an open prefix list to get things working. Some of the routes weren't being redistributed to OSPF a...

velo84 by Level 1
  • 647 Views
  • 1 replies
  • 0 Helpful votes

Hello, After configuring additional ACL entries - we're getting this error message. "ERROR: tcam region full" I wonder if this is true or a bug. If the message says tru - how can i check the TCAM numbers ? Im using older NXOS version, but willing to ...

from88 by Level 4
  • 1647 Views
  • 1 replies
  • 0 Helpful votes