Does cisco provides Edge Gateway devices, if yes please send me the specifications, its pricing and its weight, dimensions, also which ML models it supports for Edge computing
Forum Posts
Catalyst IR1800 Rugged Series Router is certfied E-Mark?
Resolved! Cannot reset IE-1000 Industrial switch
I recently purchased several of the IE-1000 switches and exploring the GUI. Unfortunately, I mis-configured the switch and now it is inaccessible. I would like to reset the switch back to factory defaults. However the instructions don't seem to ma...
Pre-Sales Engineering Question:When the IE-5000 ( H-Stacked ) and/or the Catalyst IE-9300 (IE-9320-22S2C4X with GPS/GNSS, StackWise) are Stacked, how does the combined switch IOS-XE instance deal with the presence of two GNSS receivers?For simplicity...
We have a number of IE2k, IE4k and IE3x00 switches installed on our production sites. One of the benefits are easy replacement of faulty switches by operations personnel, without networking knowledge, by moving SD-flash card to the new switch. During...
Resolved! "ntp refclock ptp"
All:I recently purchased a Catalyst IE-9300 for comparison/replacement of the IE-5000.I see the Catalyst IE-9300 supports "ntp refclock ptp" (*) allowing NTP reference clock to be PTP Boundary Clock (PTP Client).Are there any other IE-series switches...
In today’s fast-paced and highly competitive business environment, success often hinges on having direct access to the decision-makers who shape corporate strategy. At Ready Mailing Team, we understand that reaching top-level executives can be the ke...
IE3300 Switch will not boot after cycling power on it. I would appreciate some guidance on this issue. I tried talking to it through putty to trouble shoot. I had no break through and I also tried downloading an up date it seems to just be locked. I ...
We have two IE 1000 6T2T switches we cannot factory reset. The manual (attached) states to do the following: To reset the switch:1. Press and hold the Express Setup button (recessed behind a small hole in the faceplate) for about 15-20 secondswith a ...
Hi everyone,I'm experiencing an issue with multiple IE-3300-8T2S-E network switches installed with PWR-IE65W-PC-AC power supplies. On several occasions, these power supply modules have suddenly blacked out and stopped working, despite a stable 240VAC...
Hi, I have an issue with IE-4000 relay alarm (maybe same thing with with IE-3200). We are using NC = Normally closed in all other manufacturer ethernet swithces and we need to do the same with Cisco IE-4000/5000/3200 swithces. We have connected cable...
IE4000 (or Stratix 5400) user question: Has anyone successfully made VTP version 3 (or v2) work over a PRP interface? Debug sw-vlan * seems to show the VTP library transmitting VTP on the PR1 meta-interface instead of the underlying physical inter...
Hello All,I tried to configure REP and PRP on IE 4010 switch. But I can't find the commands suggested in the documentation under the interface.License Level: lanbaseSW Version: 15.2(8)E1Commands Not Supported: switch(config-if)# prp-channel-group 1 S...
I'd like to know how to recover and initialize passwords for the 3000 series. I'd like to change only passwords, not factory reset, is there a possible way? https://www.cisco.com/c/en/us/td/docs/switches/lan/cisco_ie3X00/Hardware/installa...
The IE3300 is having problems not dropping frames when two Basler Cameras are connected to it. The competitive Fortinet switch is able to when Flow Control is set to TX, why can't we set it to TX on the IE3300? Or how can we configure the IE3300 to s...
