I am bit confuse about the utilized Ampere calculation of Router and CISCO Power calculator. 3 power supplies (a9k-3kw-ac-v2) are installed in ASR-9010 and router output showing total 2082 W power being utilized and 38 Amp ( 12.7 + 12.5 + 12.8 ). ...
Hi every one, I have been struggling a whole day to understand the real differences of Precise Time Protocol (IEEE 1588) and Synchronous Ethernet (syncE) and their role in the network. Greatly appreciated if you help me. So, my questions: 1- Does the...
Hello, I have 6807xl box and I configure all ports of it it as L2 dot1q trunk and I have so many 3750 switches that they connected to the 6807xl as L2 dot1q trunk.In all of them VLAN 1 as management VLAN and every thing is OK.I checked there is one ...
Hi, CSC: Can someone please provide a full list of 1G SFP support for the asr920 for the 24 SFP ports (part number ASR-920-24SZ-M).I'm particularly interested in the BX (bidirectional) SFP support. Data sheet and HW inst guide do not include this lis...
Dear i am girijesh singh , i have cisco asr 9010 router , now a day they are showing low memory warning and due to this our maximum BGP session are down frequently with msg (OOM) . kindly suggest how to resolve this issue
Hi All We have purchased the Cisco catalyst 9300 switches and replacing them with HP5500. The switches will be used as Core in the network. I haven't worked on these switches before and looking some help in stack configuration. Please share the sta...
Quick Synopsis I have a customer that is currently running a L3 MPLS network across the United States. We are looking to convert this entire network to a L2 VPLS solution as its more cost effective for higher bandwidth throughput. Current Layout...
Hello community. I need help with Cisco ASR-920-12SZ-IM. From the first start, the STAT weapon is red. Is it normal? Is there a hardware failure?
We recently added a service provider that will provide us with Provider UNI's to each of our customer sites. They will carry traffic across there backbone and pop/remove their S-vlan at each site and each site has a unique S-vlan tag. All customer si...
Hello, I am seeing an issue in which my SLA operation's return code is OK, but I'm unable to obtain any measurements. When issuing a 'show ip sla stat [op #] detail', I see measurements being initiated as expected, but none are completing: ho...
Hi, Last few days, tried a lot to figure out a silly problem but failed. I tried to fix a customer bandwidth who has taken 100Mbps bandwidth from us. When we use Policy-map with Police Cir, our end is showing more than 110Mbps but client is getting 9...
Hello All. I have the below ACL applied inbound on a vlan interface, int vlan 808. I would like to match against this ACL in a class-map and then apply it to a policy-map that'll set the dscp 10 for ssh and tacacs traffic. All other traffic I do n...
HI Guys, what is the switchover time will be taken for ASR 903 RSP-3 switchover from active to standby.
Hi, I'm currently working on this setup and I would like to seek your opinion and expertise about this setup. From Customer they will send multiple tag (3320-3322). But in this scenario, I only inputted sub-int of .3320. Supposed to be if Custom...
Hello, I'm using SevOne for monitoring and I'd like to monitor the optical TX and RX light levels on the ASR 9000 chassis and the ASR 9000v satellites. Does anyone know of the correct OID that would help with this task? The only ones that I've been ...
