Hi,I am trying to create a typical provider topology in GNS3.I would like to know what IOS to use for the:- P routers- PE routersAlso the minimum Hardware to use for:- P routers- PE routersI am also going to use OSPF for the IGRP on the MPLS devices....
Hi all,I'm hoping I might be able to get some insight into how a BGP free core mpls network handles certain senarios.I understand that with a BGP free core you can have a customer connected to a PE and announce a network which will be reachable from ...
Hi Any one can help me to know various metrics which are must or needed to monitor different parameters on MPLS Network. Few parameters which I have are :1. LSP Utilization : To know the over all bandwidth used.2. LSP Error : It would be great if i h...
I have two vrf lite instances and I want each vrf lite instance to have its own default route to the provider internet.Provider is providing two VLANs and each VLAN has access to Internet.When I remove the global default route I am not able to get ou...
Hi,we have a MPLS L3 between our branches, recently we are facing problem with branches connecivites.our setup is 7609 router connected to CE 3900 branch router, we are using a Interface Vlan to route behind the CE subnets.CE using sub interface with...
Hi,We are running some 7606 boxes using MPLS, however when we check ;sh int te 3/2 accounting TenGigabitEthernet3/2 Protocol Pkts In Chars In Pkts Out Chars Out IP 3546160 3748935104 312 470...
I would like to know if ASA is an VRF aware firewall. I have this scenario wherein I have multiple clients at the edge on two different sites and I want them to be separated in RT with advanced security features. So I opted to use vrf lite and vFW in...
Hi everyone,I am trying to build a real life topology. My goal is to exchange private routes between 2 MPLS provider via the public internet without leaking the private routes to public internet. So the router in the top right corner should be able t...
Looking for efficient OID for detecting if a remote router is a LSR or LER!I found that we are able to determine if an LSP is originating or terminating on router using "mplsInSegmentLdpLspLabelType" but it seems to be not at all sufficient/efficient...
Hi,We have a situation here. We need to configure BGP fail-over. We have two ISP links (ISP1 & ISP2) from two different locations which is connected to our remote site.And we have already configured BGP on remote site with another ISP(ISP3). AS is 1....
Hi,We want to build a MPLS core network using microwave equipment.In some situations there could be multiple microwave links between two routers, as below.R1 ----m1-----m2-----m3---- R2R1 and R2 are routers running MPLS.m1~m3 are microwave bridges. ...
Hi guys, im reaching you because i have tried everything and nothing is working, here is the situation:- We have implemented TE on our network, and everything was working fine before, we had Cisco 7600 equipment with Te tunnels using affinity, when w...
Dears,hope you support me understtanding the following:i have the following topology: now i need CE1 and CE2 communicate to CE3 ( CE3 connected to mpls through ethernet) over MPLS cloud and be aware that mpls cloud working perfectly but my head...
