Dear AllI am trying to test the use of ORF with extcommunity using "bgp rr-group" to make the PEs not advertise any routes with extcommunity which are not allowed on the RR using " bgp rr-group" command..I am not sure if I have misinterpreted using "...
Hi, I am trying to test all mode of MPLS QoS tunnle mode like uniform,etc.My diagram is as below:CE01 --access--> ME4900 --trunk--> PE01 --ldp--> P01 --ldp--> P02 --ldp--> PE02 --access--> CE02All traffic from CE01 are marked with DSCP AF31 an send t...
Good morning everyone.... I was wondering if someone could help me out with this?I have setup a dev lab setup to test some stuff out before I go forward and move to production but I have hit a brick wall...Here is a general setup Diagram. ...
What is the value of the domain-tag if we have two PEs in different AS umbers (inter-as mpls ) and if we configured the domain-tag value is this should solve the loop problem as the attached file
HQ connects to 2 different remote sites via MPLS.:HQ connects to PE1 via MPLS vrf SITE1HQ also connects to PE1 via MPLS vrf SITE2:WAN1 connects to PE2 via F0/0 vrf SITE1WAN2 connects to PE2 via F0/1 vrf SITE2:HQ sees all prefixes from both remote sit...
pls take a look at my question and diagram is attached in the file. pls help me to fix this problem.I have following requirement about traffic paths within the MPLS network.MPLS network is running MP-BGP4.1.Traffic from Europe branch to Asia branch ...
Dear AllIs it possible in a Service Provider Environment for the SP to offer both Per-Destination and Per-Packet Load Balancing Services to the Dual-Homed MPLS VPN Customers simultaneously ie Customer A wants to have Per-Destination Load-Balancing ac...
Hello,I need to NAT between a pair of VRFs. I understand the simple examples in the documentation where you have customer X and customer Y (each on their own interface/sub-interface) and want them to share a 3rd interface such as an internet connect...
Hi All,I have a 7200 router connected with ME3600 which further connected with other MEs in ring topology. I need the 7200 to waork as BRAS. the media in ring is ethernet and i want to use Layer 2 pseudowire to transport DSLAM data traffic to BRAS. c...
When I traceroute to an IP address belong to a vrf, I saw that it always has one hop with 2 times appearances. Please help me describe the problem?Here is the results:HZZ-ZZZ-7609-01#traceroute vrf VPN-XXX-YYY 172.16.2.62Type escape sequence to abort...
..I have a customer who uses MPLS to connect to all remote locations. The MPLS carrier has recently merged with another carrier, and they are in the middle of making changes to their MPLS network(s). As a result, some (but not all) of my customer's...
