Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Please help answer some questions on MPLS to help me understand the concepts better.Q1) Pseudowire concept is used only for MPLS L2VPN and is not supported for MPLS L3VPN. Is this correct? Please provide doc/urlQ2) L2TPv3, EoMPLS, VPLS which are M...
Which of the following could perform accounting.A. RMONB. NBRAC. MPLS D. SNMP-MIB E. AAA F. BGP policy accountingWhich of following mode is correct for MPLS VPN1. unicast over GRE2. MBGP over GRE3. Multicast Over GRE4. Multicast Over Mul...
Hi there,i have two vpn routers in my datacenter which is connected to MPLS cloud and around 1000 branch connected to mpls cloud by using BGP. i want to configure Qos for the ip sec traffic and make sure that this ipsec traffic is getting high priori...
Hello Experts,Can somebody brief on why Domain-Tag or Domain-Ids are required when we use OSPF as CE-PE protocol.Also my 30 sites connected to two different MPLS providers. Say Provider-A and B.Provider-A is primary for all traffic and B links are ba...
Hi,Apologies in advance but im new to MPLS, But is possible to have more than one pysical interface in a tunnel and is it possible load balance accross the physical links ?
Hi Experts,We have a network running MPLS TE tunnels in the core. Cisco CRS-1 (IOS XR 3.5.3) in the core layer and 7609S (IOS 12.2(33)SRB2) at distribution layer. MPLS TE tunnels form full mesh from any 7609S to any other 7609S. It is in production.D...
We have one network link need to run MBGP using interface establish, not use loopback0.I tested from lab environment and ping test from R6-CE src:6.6.6.6 to R1-CE dst:1.1.1.1 fail, becasue ldp label pop at R4, not R3.R3 should be Penultimate Hop Popp...
Hi,Is there any way to use the IGP cost between PEs, and pass that into the VRF prefixes?For example:A branch site has 2x CEs (CE-A & CE-B), each with a link to a different PE (PE-A & PE-B). EBGP is used between CE-PE. IBGP Between CE-A & CE-B. CE-C ...
Hi, We have a customer, who is getting intermittant poor response issues over their MPLS network.When they experience these issues & do a traceroute between the 2 sites, they get the following output...traceroute to 10.0.0.2 (10.0.0.2), 30 hops ...
Hi Guys, We have a MPLS based core network. At this stage they have 2 sites in Different cities. We configured xconnect for them. Both sites are ethernet based..Because it was point-to-point we configured xconnect..Now they have a new site comi...
Hi thereI am planning to migrate our whole network from TDP to LDP gradually. Is there any issues in dhaving TDO & LDP running on same box during migration phase. and when I assume session will be down temprarily while tearning down TDP and setting u...
Hi all,Is there any options to see what tunnels are passing through one router . for ex: i have logged in to R1 then how can i see which tunnels are passing through R1 and their status.Regardsthanks in advancemahesh
