MPLS

Hi,We are getting this message each hour. Anyone know what's going on? The Output Interpreter is not clear at all.Nov 15 09:16:26: %TFIB-SP-7-SCANSABORTED: TFIB scan not completing. Unresolved adjacency. !Nov 15 09:16:43: %TFIB-SP-STDBY-7-SCANSABORTE...

Hi In an Enterprise Network we are using CAT6500 SUP720/MSFC3B with VRF Lite.According to the Software Advisor VRF aware NAT is not supported on the 6k. But I think with the MPLS image it should be supported. My question: Is it supported and if yes w...

HI,I am planning to use SUP32 with 12.2SR IOS in one of my distribution switches. We have WS-6408A-GBIC and WS-6516A-GBIC modules without any DFC. Can I have MPLS VPN and EoMPLS support on this box.Thanks,Prakash

I have configured OSPF in my network into 2 areas (backbone & area 1) for supportingMPLS. Now i have somes problems with it.1. I verify OSPF on the R1R1#sh ip route x.x.y.1Routing entry for x.x.y.1/32 Known via "ospf 1", distance 110, metric 2, type...

Hi..I have a doubt in AToM Pseudowire.. I ve got a AToM pseudowire setup between my two PE routers with lastmile being on Ethernet sub-interfaces with VLAN tag on both the ends. I want to confirm while the packet traverses from PE1 to PE2, the VLAN t...

hi, I have a couple of simple questions regarding MPLS and would be appreciate to every help: question is: Is it stricly necessary that CE and PE (in MPLS terms) routers are directly connected? Or is it possible to create CE-PE interconnection via In...

Hi We currently use a BT MPLS network and use BGP on our CE router to peer with the providers PE routers. Currently we only use one VPN for production across the MPLS network. We are now looking to give access from some of our MPLS sites to a test en...

I want to implement MPLS _ TE.If my A-D link fails (it is primary link) then i want my traffic will follow the given pathD-B-C-A.For this i need MPLs-TE configuration.regardsshivlu

i want to know do we get the tunnel update in ospfshivlu

Can i create two MPLS TE tunnels from PE A to PE B with the same destination address as the loopback of PE B with "autoroute-announce" enabled being two tunnels have different explicit paths created ?e.gFrom PE A:int lo0ip address 10.10.10.1 255.255....

192.168.165.245/30dot1q -------------fe2/1-RTR(CE)--VRF-lite & dot1q---(PE)RTR192.168.165.249/30I have 192.168.165.0/24 resident within my IGP on the CE. But I also /30's from the same address space configured on my interfaces. As such when I add th...

Hi,Here is the picture: two multimode direct fibers between PE - PWe are trying to figure out what is causing these erros. No physical issue, we changed both fibers and Gbics... Here are the "sh int" outputs:PE#sh int gi0/0GigabitEthernet0/0 is up, ...

please let me know if we are having two paths in the igp primary cost is 40 and secondary cosct is 80.but when i create 2 tunnels one for primary and one for secondary at that time my load balancing occurs in both tunnels with cost of 41.As i know TE...