MPLS

Got one question, I'm going to upgade a couple of 7600 running Sup720-3B.. If I have interface cards with WS-F6700-DFC3B, can I upgrade the supervisor to a Sup720-3BXL, and keep the cards running DFC3B, until I upgrade them to DFC3BXL, or do I have t...

Hi guys,I need your help on checking my mpls atm configuration. I'm not sure if I configure it and understand the terms using to call each mpls atm scenario correctly. (it's working though)#1. Frame Based MPLS ATMls1010interface atm3/0/0 atm pvc 1 50...

Hi All,I have 2 questions. 1) Does Cisco Router 7600 with SUP720 3BXL supports VRF Selection based on Source IP Address [Layer 3 VPNs]? 2) We have various clients reaching a Router and we want to forward them to a their company's VRFs, based on thei...

Folks, Reading documentation on CCO on how to enable support for jumbo frames on the catalyst 6500. Documentation talks about enabling it on per port basis. Can i enable support globally??? and not worry about enabling in on every port??Also, w...

Folks, we have 2 core switches (6500 3XLBs) at the core doing inter vlan routing.I plan to move towards enterprise MPLS as a test pilot. My question is that as follows:Lets say that i have vlan 300 terminating on both core switches. both core s...

Hi,Just want to know, normally, I get xmit/recv, but from this output, it shows active/passive. What could it be if the active/passive status is shown in below command?PE1#sh mpls ldp discovery Local LDP Identifier: 192.168.1.97:0 Discovery Sou...

I guess what is the conform bust and peak bust.I see cisco web page bellowhttp://www.cisco.com/en/US/products/sw/iosswrel/ps1829/products_feature_guide09186a00801b2404.html#76432I think if data traffic in cir than conform action and pir than exceed a...

Hello Everybody,I am trying to deploy QoS for EoMPLS ERS service and would like to offer four Class of Service on a single ERS VC. I am trying following config on Cisco 7606 Router with SUP720 3BXL and PFC3BXL.My customer facing port is Gig Ethernet ...

Hello,In the cco i dis not find any explication for the following message: MPLS: Et0/1: recvd: CoS=0, TTL=255, Label(s)=18/212d05h: tagsw_replace_header: Pkt drop -- EoS conflict, incg label 18 hwinput Et0/1Thus any one has some clue.thanks

Hello...Please Help,I have a Single Area OPSF network running across 4 main routers via GigEth Ckts. The OSPF Network is working correctly. I recently implemented MPLS TE creating two Tunnels - One Explicit Path and One Dynamic Path. Two of the Route...

Hi:Based on paper titled "L3 MPLS VPN Enterprise Consumer Guide" page 52, figure 44. (http://www.cisco.com/en/US/partner/netsol/ns465/networking_solutions_white_papers_list.html). 1) The figure discards the "streaming video" and "bulk data" traffics ...

Hi:Based on paper titled "L3 MPLS VPN Enterprise Consumer Guide" page 16 (http://www.cisco.com/en/US/partner/netsol/ns465/networking_solutions_white_papers_list.html). My SP has only 3 CoS for its VPN service. I have classified up to 10 different cla...