Network Access Control

Which comand is used for a separate p2 auth?

Hi to everybody.Why i can't see all the radius attribute from the interface configuration html page ?I need to set the primary-dns-server (radius attribute number 135) and the secondary-dns-server (radius attribute number 136) radius attribute, but i...

hello cisco people! Need your help. Below is my running configuration of my PIX515e.Here is the network topology:http://img145.imageshack.us/img145/5598/pix515eap6.jpgThe problem that I am trying to solve is I want that my inside users (network 192.1...

Dear SirI have implemented port basted authentication for my network via Radius (ACS) and all the computer can connect to the network via switch without problem and I have considered to apply this authentication to my wireless network for authenticat...

ASA 5500. Is there any way to get Login/Logout Session Reports from the ASA 5500?

I wan upgrade ACS 4.0 to 4.1 on ACS SE, i have read document but i don't have ACS SE 4.1 Upgrade CD, please guide obtain ACS SE 4.1 Upgrade CDthanks ducnv

Hi there, After going through some topics and trying everything I could fine I am relaying on you all to help me further.I have an Switch and have an AAA configured for login via ACS with AD account. All works fine via Telnet, but connected to the co...

Hi allI need to deploy 802.1x with mac-authentication in the network.Network Specificatios:> The network diagram is attached.> The connection between the branches are 10 Gbps and are operating through OSPF routing protocol.> The ACS (4.1)appliance is...

Hi,I have installed CAR 4.1.3 on solaris 10 when I tried to login to aregcmd ./aregcmdCisco Access Registrar 4.1.3 Configuration UtilityCopyright (C) 1995-2007 by Cisco Systems, Inc. All rights reserved.Cluster:User: adminPassword:Logging in to loca...

Hi all,We hade ACL installed on a wmware server up and runing.After moving this server to a new wmware server "new hardware" the admin gui is blank when we try to connect "http://127.0.0.1:2002/"We have try to restart all the services.Any sugestion?R...

HiI configured ACS to authenticate users from AD Server.If I enable "Use Secure Authentication" to ldap (ad) server then I does not work.(Trusted Root CA: I now that I have to set the root certificate)If I use "Certificate DB Path" cert7.db file then...

show tacacs Server: 10.10.2.80/49: opens=47 closes=47 aborts=0 errors=0 packets in=0 packets out=47 timeout=0 connection_fails=1 no connectionwhen in = 0

Hi,i'm trying to configure SNMP on an ACS appliance(System configuration => Appliance configuration => SNMP agent). There is also an option "accept SNMP packets from selected hosts". When i enter an IP adress in the "Host Address" field, i receive t...

Hi guys,I attempted to configure remote access VPN using cisco 837.IPSEC and firewall features were added already.However, the VPN client keeps saying "remote peer no longer responding".Upon removing firewall and ACLs, VPN client works. Therefore, I ...