Network Access Control

trying to implement dot1x on wired network with dynamic vlan assignment, very unstable. anyone with fix or similar results.

Hi I have stack of 2950 switches. I have configure tacacs for login security purpose. but i am facing problem when i open CMS web interface. I am succussfully get authenticated. but its get hang when Discovering network information dialog box comes. ...

Hi,I'm working with 802.1x over catalyst switch, ACS 3.1 as Radius and external DB users authentication on Ms Active Directory with LDAP.My questions are:1) Are the only EAP's version supported by catalyst, MD5-EAP and EAP-TLS (not PEAP and LEAP);2) ...

Under Shared Profile Components/Shell Command Authorization Sets in ACS, is it possible to enter a wildcard for further arguments.For example, say you want to permit show cam [+ all arguments], is it possible to configure show, then 'permit cam *' as...

I have a VPN Concentrator 3005 that I have two groups configure, one uses internal authentication and the other kerberos/ad. The group that uses internal authentication can login without issue using the WebVPN, the group that is configure with kerbe...

On our 6509's I have Tacacs setup on both the switch and the router. When I try to session 15 from the switch to the router I get in but when I enter my Tacacs username and password it says Authentication failed. I then go to the Tacacs server to s...

Is the licence to a single instance of the above. Or can you legally run multiple instances on different box’s

I have been trying to get the Accounting to work following the guides on the cisco site. I can not get anything to come up in the logs on the ACS server. Also when I go to Logged in users and it lets you pick a AAA client the test switch that I am u...

Hi,I have configured Guest Vlan in switch port, when i power on PC and i didn't make login, PC after some time goes to Guest Vlan but it didn't acquire an IP address and after some time port goes to unauthorized state and then after some time goes to...

I am trying to do some account management. Is there a way that I can automatically anwer "yes" after I complete the csutil -i <update.txt> statement? I had to insert the work offline in there, but I would like to automatically update this, but I ca...

Hello,I was trying to get TACACS+ setup on a 6509. I never set the console or VTY to go to the ACS server for authentication. I only setup the groups and the host addresses. When I try to connect to the MSFC it asks for username and password. It ...

I need to know if I will be able to install the Oracle ODBC drivers on the ACS appliance. I am currently running ACS 3.2, but plan to upgrade to the appliance next year.

HiI've installed & configured xsupplicant on RHFC1 but an error is accured :Error for wireless request "Set ESSID" (8B1A) : SET failed on device eth0 ; Operation not supported.I would like to run PEAP on linux in a wired LANHelp me !ThanksThanks

I use :- Cisco 837 as Easy VPN Client devices on remote sites- Cisco PIX 515E as Easy VPN Server on central site- CiscoSecure ACS as TACACS+ Server on internal LAN of Central SiteThe remotes sites connect to central site by ADSL with 3DES VPN Tunnels...

Dear All,May I know if the latest ACS enginer server contains any DVD-ROM drive?It only mentions floppy disk in data sheet.Regards,mak