Network Access Control

Hi,first: the above msg is not found anywhere on cisco.com, not even on the error message decoder.We have routers configured to use aaa and tacacs+ to give administrators access to the exec. Tacacs+ server is CSACS (two servers). The servers are reac...

unable to get tacacs working on a 2500. Tried several different ways to configure it. but I believe I am not doing something correctly between the AAA commands and the vty 0 4 line. It normally looks for a tacacs server (hesitates) but then goes to a...

On an IOS router, I can log the commands a user enters to a TACACS server with:aaa accounting commands 15 default start-stop group OSFMC These commands are logged to ACS and can be recorded...Can I do the same thing with PixOS?

Hello there,I'm having this awkward problem with IOS 6.3.3 while using AAA authentication. Because the authentication sends an HTTP page asking for userid and password in SSL. I get a popup stating that my SSL certificate does not match the web site ...

Hello, I want to connect to VPN 3000, groups are configured on ACS server and users are stored on a LDAP server. I want to assign IP to VPN client from the VPN 3000 but I want a different IP pool for each group configured on ACS. On ACS, I don't know...

I have problem to make aaa authorization work with the acs server for test purpose.Here is the router configaaa new-model!!aaa group server tacacs+ cisco server x.x.x.xaaa authentication login default group tacacs+ localaaa authorization commands 15 ...

Does anyone have a sample config of downloadable IP ACL in IOS 12.3(8)T? I know it can be done with Secure ACS 3.3, but have no idea on how to configure it on the router.

We recently enabled AAA on all our routers for device authenticationa dn authorization. When we did this it broke our async dial back up on some of our routers. Basically as soon as you enable aaa new-model, the behavior of PPP Authentication changes...

I going to install a ACS for our wireless system. i will have 23 1200 and 12 1300 unit. i will have three tunnels one for Network access, one for wireless voice and one for PDF access. what will happen if the ACS go down. what can my back be.

I am trying to use ACS server authenticate login and enable password for users to access the router.Here is router configurationusername test password 0 cisco aaa new-modelenable pass cisco!aaa group server tacacs+ cisco server x.x.x.xaaa authenticat...

Hi all - We use the configuration management piece of CW2K to download each of our device configurations. We are looking at going to AAA using SecurID for authentication. However, if we setup our VTY access to have an authentication scheme of '...gro...

837 with ...interface ATM0 no ip address no atm ilmi-keepalive pvc 0/38 encapsulation aal5mux ppp dialer dialer pool-member 1!Dialer0ip address negotiated encapsulation ppp dialer pool 1 ppp authentication chap callin encapsulation ppp ppp chap hostn...

HiI am having a problem with AAA Authorization and Microsoft IAS. I want to pass of authorization for network (PPP) access to MS IAS (radius). At present it fails but it never makes a request to the IAS server. I am running a packet sniffer and never...

Hi,! I have a problem with ACS, I must have 2 profiles (I belong to 2 NT groups) for remote access when validating in an ACS. I create firt group, map my NT group to it, WORKS! then I create second group, I map it to NT group, HOOPS ! again first gro...