Network Access Control

I have the following set up...Win2K with RADIUS running and working with authentication of my PPTP sessions on my PIX515...I have verified it works with multiple user accounts...I would like to start exspanding RADIUS to authenticate more than just m...

I have setup a table in a SQL Server 2000 database with user names and passwords for testing purposes and when trying to run the stored procedure creation script for CHAP (per the ACS user guide instructions), I get a lot of errors. They are:Error:Se...

I have a client with a VPN 3005 concentrator, and they want to authenticate against their Windows 2000 Active Directory. However, the AD servers are running in Mixed-mode.I have tried to configure the VPN 3005 concentrator to authenticate against the...

Hi:I already bouught VMS and am about to install it. Have mainly three questions:1.- I want to install it in same server I installed Cisco Secure ACS. Because with ACS I used the Common Services CD, but with version 2.0, I see that with my VMS I rec...

Hi,Initially all my clients are Window 98 users and they have no problem mapping their drive after successfully dialin to my company domain. The login script execute qutomatically after their username and password is authenticate via ACS.Currently, I...

Hi ,I have installed RADIUS Server on Windows 2000 Server, I am able to login using windows 2000 User ID. But not able to login directly to pril level.How can i do this ?Following is my config on router,aaa new-modelaaa authentication login default g...

I have an ACS 3.1 server, and the user changable password server is running on IIS on an NT 4.0 server. For the most part, this works fine, but recently, one specific group on ACS has been saying that they cannot log in to UCP and change their passw...

Does anyone know the max concurrent authentication sessions supported by the ACS3.2?

Our router is configured as a RAS using local usernames. I want to log user activity (log-on, log-off) but can't figure out how. I've been working with a test router (Cisco 2510) running IOS 12.0(17a). I've also been using a Windows 2000 workstati...

Does AAA authentication from the outside to inside only work on port 80?I've configured the PIX 525 (6.2) to allow an incoming connection on port 5800 and 80 to a specific IP address for which a static exists. I've also configured AAA authentication ...

Hi. I would like to use peap-ms-chap v2 authentication within acs 3.2, who can help me to find out relative documentations. Thank you very much.

We have currently got a number of users who forget their passwords, change them and then seem to forget them again in a matter of 2-3 days, we are looking for a way of decrypting these users passwords from the Cisco User DB in ACS 2.6.4.When I do a ...

We have a VPN 3030 authenticating to CSACS 3.1. I read somewhere that 3.1 allows you to put a per-user access list in the user profile on ACS, without having to put any filters on the VPN 3000. I would like to do this, but have been unable to find a...

I am attempting to set up a couple of different user levels in are ACS server. Group 1 will have all privilages (15). Group 2 will have limited access to command sets (help desk folks). I was hoping I could avoid putting any "privilege exec level" ...

I am trying to get multiple users to use the same machine but have different vlans assigned. i.e if user 1 logs in he gets vlan 1 if user2 logs in he gets vlan2. This works fine if I reboot between users, however, if I do shutdown, log off user1, th...