Network Management

Accounting options with RME4.2 (CW LMS 3.1)

I configured cisoworks LMS 3.1 to use ACS authentication. "ciscoworks" is the username provided to it for SSH/ Telnetting to the devices. Is there any way to check whether a configuration change made is via the CW GUI or through the CLI of the CW ser...

LMS and device IP change

Hi,I have a very general question about LMS. If my devices are added with IP address and I change a IP address of a device, what effects would be there in CiscoWorks. Does the Ciscoworks automatically detects the change and apply it to the device or ...

Resolved! Extracting from Syslog msg !

Hi all, can someone tell me how can i write a tcl script that extracts information from the syslog message that generates the eventFor example if this is my event ::cisco::eem::event_register_syslog pattern "%CRYPTO-6-EZVPN_CONNECTION_UP: (Server) M...

topology map device not coming after delete

hi to all,I am facing a unique problem in ciscoworks, actually what hpnd after clearing ospf route, the core switch turned red with all devices conneced to it though i have no problem in core swich and its working fine but all red link on core didnt ...

Resolved! RAID controller monitoring

Hi,Is the CUOM able to monitor RAID controller events for the IBM servers where CUCM and other Cisco products are installed?thanks.

CiscoWorks RME 4.2 Compliance Check Fails on SNMP Strings

All,RME 4.2 Compliance Check does not work when you try checking SNMP strings, passwords, or TACACS key because they're encrypted in the config archive. Is there a way to configure RME to have Compliance Check look at the actual value?Stephanie

CiscoWorks RME 4.2 SWIM Remote Staging by Device

All,CiscoWorks RME SWIM Remote Staging by Device procedures state to select a device that supports remote staging. How can one check a device to see if it supports it?Stephanie

Cisco NTP issues

Hello all. I have a Cisco 2811 router on a lan network. I have NTP turned on on this machine, and have assigned a valid NTP server that another edge router we have uses. Internally, local machines asking this router for NTP get results just fine. How...

All WLC on LMS 3.1 are showing duplicated Sysname

I am getting discrepancy errors on all Wireless controllers. The discrepancy details points to the same IP address???.They sure have different Sysnames and IP addresses.The wlc's have two connections each one to a 6513 core switch.On the 6513 Device ...

Resolved! Is it possible to automatically import SAA's from devices in IPM?

Hi,we have a LMS 3.1 in a Windows server. We have some devices with some SAAs defined for another management tool.Now we want to test IPM and we want to know if there is any way to automatically import these SAA collectors defined in the devices into...

QPM 4.1 and HUM1.2 for LMS3.2

Hi Guys, We planning in deploying QOS in our network and due to the size of our network we are planning to buy the QPM module for Cscoworks. But initilally i need to make some notes of the advantages of it to my team leader. Did anyone use it, if so...