Network Management

LMS 2.6RME 4.0.6We have an MDS9134 that is failing config archive with error messageCM0056 Config fetch failed for DR-9134-01 Cause: CM0204Could not create DeviceContext for 226 Cause: CM0206There are no device or software updates using software cent...

Are there any good freeware monitoring applications which will enable engineers to determine data flow & possible impact SVI, interface and etc.

Hi AllIn Campus manager topology view some devices are not connected to the rest of the topology diagram. Why is that and How we can correct it?Regards/Asfar

I have installed cisco works evaluation version. I am able to add devices manually through device management. How can I populate my ciscoworks with Devices through network discovery

hi all, can someone tell me that in order to run netconf do i also have to learn XML, referring to the doc below http://www.cisco.com/en/US/docs/ios/12_2sr/12_2sra/feature/guide/srnetcon.html#wp1063896It seems that i must know XML in lot depth to gra...

Hello, Is it correct that CSM is more of a policy/configruation deployment facility rather than monitoring one. Features such as network, bandwidth, device/health status monitoring are not available on Cisco Securit Manager. Is it correct.Thanks.

Hello, I can ssh from the CiscoWorks server into IDSM device. But when I 'Check Device Credential' thru device center, it is blank against ssh and 'Did not Try' for Enable By ssh. Doing ssh into IDSM takes directly into the privileged mode. Thanks.

Anybody knows if CiscoWorks LMS 3.1 is supported by Windows 2008 Server ?

I had solar winds and it had an IP browser. I would enter the community strings in and the subnet/ip that the switches were on and it would tell me all the switch names and their IP address.I don't have that anymore. Are there any free tools I can do...

When I use Report generator from Campus User Tracking to run report on End Hosts with All Host Entries option, the report doesn't display ip & hostnames of endhosts connected to switches, shows only mac-address which I assume are the host mac-address...

I have configured our switches with syslog traps and syslog server as LMS server, but I don't see any messages under "syslog Alerts" in RME module. The messages are collected fine on another linux box. I don't see much configuration of syslog server ...