Network Management

Hi, I have new devices add and when i view by topology service, they appear as a green box with ? instead of the switch picture. Those device are 2960 and I already install the latest device package. These device can be view by Ciscoview correctly. ...

my Device Discovery status "Running" all the time. I would like to stop it to change the Discovery settings. as for now, it didn't let me update the change.

We are looking for suggestions on tools that organizations use for managing large IOS files. Our issue stems from the fact that the TFTP protocol doesn't handle files larger than 32mb. We were using SolarWinds TFTP server. Thanks in advance for yo...

Is there a command(s) that can quickly show me a list of ports and which ones are in error-disable mode? I have not come across a way to do this.

I have LMS 2.6 installed and have successfully added a new Cisco 3650 Switch. I've verified the Switch is added correctly both in RME and DFM.I have configured an Event Set to notify me of "unresponsive" Events and set the Notification Group to rece...

What're the potential pitfalls if NetConfig is used to change the local passwords on the unsupported PIX devices below? Is the NetConfig of LMS 3.0 any less limited in these aspects of PIX support?http://www.cisco.com/en/US/products/sw/cscowork/ps207...

I am trying to upgrade the software of a 3750 switch with ciscoworks. I added the image to the repository, and created a job to push it to a 3750 on the network. The job failed.Note that Ciscoworks' connection to the device is working properly, throu...

I'm trying to have my router use Tcl to pull down a webpage from a cable modem. Here's my code so far.set sock [socket 192.168.100.1 80] puts $sock "GET /signaldata.htm HTTP/1.0\n\n" flush $sock set result [ gets $sock ] puts stdout "OUTPUT:\n$result...

catalyst 6509-E, sup720ipservicesk9-12.2(18)SXF8i can not open management page in a browser.and the http debugging shows:1w1d: HTTP: out of linesplease give me some suggestions,thanks in advance

While installing CS3.0 on a new Solaris 9 box I got the following error at the RME install, can someone point me to the solution?WARNING: the syslog server is not listening on udp/514 for messages.

Hi guys,I was told that the new Cisco 7609-s is NOT a ciscoworks supported device ...any comment ??Cheers,P

Hello, I have read this topic:http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddc0f83We're using LMS 2.5 / RME 4.0.4 with the late...