When attempting to deploy and image to a Catalyst 3650 switch, it fails and I get the below error message from the ifm_swim.log: IFM_SWIM_INFO: [Operation Progress info : Distributing image [cat3k_caa-universalk9.16.12.05b.SPA.bin] using protocol TFT...
Forum Posts
Hello, I want to access a PaBx (172.16.0.86) so I tried to do port forwarding for it in Isr4221 but still can't reach it. When I do port check on the public ip, it still shows that the port(80) is closed.What more should I do.
24-Port Gigabit Stackable Managed Switch Model No. SG350X-24 and S/No.DNI220800FY - Thank you
For NX-OS devices, is it safe to assume that the `show interface` command is supported? I can find explicit references to this command in the command references for Nexus versions 3000/4000/9000 and MDS 9000, but for 5000 and 6000 the command only ap...
Resolved! voice communication
i configure line number but it will be not set after miunts i have 3 router 2 router havnot problem
doesnt matter if its older version, i just want to practice with it
I have already installed a Cisco RV340 Router and we are already purchasing 2 internet connections 100 Mbps Primary Connection and 50 Mbps Secondary Connection as a Backup & the router is connected with dual wan. The problem is that Lan speed is fine...
Dear Cisco Team, Greetings of the day! We have recently purchased Cisco 9300 switches 48T with licenses, but when accessing the switch via webgui, I can only see the dashboard & monitoring tab! I would like to know there is a limitation on this serie...
Hi all, ASR-920-24SZ-IM with 2 bundle license I've 4 x 10gig ports (Te0/0/23 – Te0/0/27) If I purchase a interface module(A900-IMA2Z) with 2 x 10gig ports, do I need to buy additional license to activate the 10-gig ports? Thank you!//Bo
Hello My PI is out of support and I was wondering if this affects the API calls I'm making, when ever I make https://server_ip/webacs/api/v1/data/Devices for example, the response will be count = 0 and no data is coming back. and for the APIs that go...
Resolved! How do you backup the cisco prime image?
through TFTP or you can backup the image from the GUI?
I have a small networking application that requires me to forward a certain port (TCP 44158 and UDP 1680) to make it run properly. I have some 3560 24 port switches sitting around unused, and I was wondering if I have to do anything to make them for...
We are upgrading our Cisco Prime currently running 3.2 version. Please see below for the exact version, device pack and maintenance release. Would you please advise on the upgrade path to Cisco Prime 3.9.9? Just to want to make sure am doing the rig...
Resolved! Cisco 2250 IP config issues
I have two Cisco 2250-50 switches that are currently on DHCP. I inherited this network and there is almost no documentation. It appears that there was no configuration done on these switches before they were put into production; the default user id...
Resolved! DHCP doesn't work in Packet Tracer
The ProblemHelloI'm having some trouble with my DHCP Server. It doesn't work at all and the clients are only taking IP-Addresses from 'APIPA'.I'm using different DHCP Pools, which should be used for the different VLANs I configured.What I've tried so...
