Hello all, We have the several stacks of 3850 with 2 Switches in each stack, and on the project requirement we want to monitor the Memory utilization for each Switch in a stack vai SNMP. Can you please help to find the correct OID to monitor the me...
Forum Posts
my client show server reset connectionafter i set every dns server ip to 128.4.1.3 .all help will be appricated
Resolved! extended ping and traceroute
hi from wich devices i can do extended ping and extended traceroute
Dear Community, I have inhereted Cisco Catalyst 2960 access switches for a previous network engineer with an SNMP configuration that I would like to change. I receive the below traps from all switches around 2 am in the morning, which is no use for m...
Resolved! Configure replace issue.
I'm having an issue with auto-replacing a config archived on bootflash. The error it gives me isn't very informational on the issue so I'm not really sure how to troubleshoot. replace-me#show archiveThe maximum archive configurations allowed is 5.The...
Hello , I want to check what is whrite in the description , how to do that ? Thanks ! event manager applet pingevent timer watchdog time 10action 1.0 cli command "enable"action 2.0 cli command "config terminal"action 3.0 cli command "do show run int...
Hi,some end customers search the "root" password for access to cisco SSMS.it's not the same as "admin" password.they want this password of user "root", for backup the VM with there vmware and for supervision server. some body have this password? Tha...
Hey guys, We're having an issue with a FPR2130 running ASA image. The physical interfaces have been enabled in the FXOS (we also created a port-channel and associated interfaces to it). When cables are connected we can see the interface coming up in ...
helloi would like you help to understand how should i configure my switch 3650 and understand -i have a freeradius that can assign a single vlan 2 -my switch configuration :vtp mode transparentvlan 400name LAN_RHvlan 401name LAN_DEVvlan 402name LAN...
Hi, simple question here. We configured dhcp server and have configured ip helper on interface vlan. and set the dynamic ip range from x.x.x.100 - x.x.x.200 for example.if the client accidentally configure ip address x.x.x.x.120 as static ip, then ho...
hello all i have done this topology using my mobilt-PT below attached,kindly advise the BOQ for the same project thanking you in advance all .
Hi, I have read about pushing Mode button on Boot until light turns Amber. Mine dont turn Amber.I get the following on my Boot up, taken from Console CLI during Boot.Press RETURN to get started!*Mar 1 00:00:08.193: %SOAP_FIPS-2-SELF_TEST_IOS_SUCCESS...
Hello experts, We had an ASR1001-X running IOS 16.6.4 and we were using the hidden command "hw-module subslot x/x statistic poll-interval 1" to be able to monitor via SNMP every second (default is 5 secs). This command was working fine (we watched it...
We are deploying from the Cisco ISR, 1111, 4451, ASR1001X as CPEs' on customer locations.We have historicly been preconfiguring these routers before they are sent out with a setup so that theyare reachable, primarly ip adress.We have at the same tim...
Gents,I have attach files with https server 192.168.100.10 which is accessible on 1 pc and other PC's are not. I created a loopback0 interface with ip 30.30.30.30 an able to reach the https server 192.168.100.10.Now i want to achieve this.1. PC1 - ip...
