Hello, I'm looking for OID of transmit and receive voice packets.Using command "show voice lmr x/x/x" so I focus on this value below.TransmitPackets=6491183, TransmitBytes=832712831ReceivePackets=9593261, ReceiveBytes=1213052990 Could anyone please h...
I need to move from x.x.160.x to x.x.162.x. TAC provided the following:https://community.cisco.com/t5/wireless-mobility-documents/steps-to-change-the-ip-address-on-a-prime-infrastructure-pi/ta-p/3163169it does not work!!cli in as admin after executi...
I have created a CLI template and now have 46 transcripts under the Job dashboard. Is there anyway to export the results from the Job Results to a csv or txt file. The template ran a bunch of commands like show run , show ver etc. It worked and now t...
CISCO 891FW router - unable to connect via console knowing the local ID/Password - the id/password are not excepted. Is there a password recovery procedure. Checked online but did not get a specific answer.
Hello i would like to know what is the OID number to use and get the health chassis switch 3650 alone or stackedi just want a status OK or not OK but don't know how to do it and if it s possible have you got any idea ? Best regards
Hello All, I have little to no experience with ACLs, and have a task I am trying to complete. I have two networks that I am looking to segment, VLANs 229 and 230. Here is the interface configurations on my router:interface GigabitEthernet0/0/0.229enc...
Hi Guys, We have ASR1001-HX and ASR1002-HX in our company. Each router has 8 x 1G ports and 8 x 10G ports. Currently we are using all the ports in 1002-HX and 1001-HX is out of production. During first implementation of our network local cisco suppor...
Hi All,My company has a Hub and Spoke topology, and 26 routers in the HQ and another two DR sites.We are running OSPF and BGP in our enterprise but we also have many ACL, static route and PBR.Unfortunately, we do not have good documentation. So when ...
Hi Everyone,I'm working on a cisco Meraki MX60. The problem I am having is the cisco meraki switch is not pulling the static IP address information, it's pulling anyone IP and I'm not sure where that other IP address is coming from. Also, I am able t...
Hi My Name Is Bobi1.In the attached scenario where the servers are located?2.Which switches should vlan routing perform?3.What form and protocol should be used for routing?Thanks for taking the time to answer my questions
please respond any one my Cisco 4321 router has successfully power on but unable to enter in to configuration mode (mean not enter in to the modes user mode ....)just power on please give me solution whom we have a approach but it is not under in war...
Hello My context:-Cisco 3650-Centreon-pluggins: check_centreon_snmp_traffic with SNMP v3 i have created some vlans on cisco: vlan400,vlan401i try to use with centreon the plugins; check_centreon_snmp traffic -H xxx.xxx.xxx.xxx -v3 -u tttt -p ZZZZ -i...
I would like to create another account so this user can access to switches (9300) to do all the works as admin but no allow this user to reset his account or super admin account. I am new for Cisco. Thank you.
