Network Management

Hello we have a problem with Ciso Configuration Professional. We have a Router 866VAE-K9 running with IOS 15.5(3) on this Device is CCP 3.2.7 install. when i start this Application so get the Login Dialog and after that the first Site with different ...

HI, I am trying to mark traffic on our switch for traffic going to the ISP router. I have loaded the below config but the ISP isnt seeing the packets being marked. (We have VOIP handsets to ) Any advice would be great. class-map match-any BAmatch acc...

Hello, we're using Prime Infrastructure 3.1 and had an power supply failure at one of our 6509. Sadly, Prime did find out about this problem (I saw the error if I switched to the device view, env details) - but it did not send an email, nor raised an...

Hi guys, As per requirement in our company, our team has to automate network operations and offer a solution to our in house NOC.Which is the best open source tool to automate network operations\delivery including most of the network vendor and that ...

Hi, I am putting this out in search engine space to hopefully prevent somebody from banging their head against this wall. This may be common knowledge to some, but was not to me. Support for SNMPV3 AES192/256 encryption is specified via the draft sta...

Hi there, I'm researching on options to make my network automated for two cases: 1.- VLAN for Printers, I need a way that every time a tech move a printer from one port to another the port automatically will check the mac or the first half of the mac...

Have a interesting project that would require us to have a switchport change which VLAN it's configured to based on a specific device being plugged in.  Device has a unique MAC prefix for this manufacturer and would be plugged into a Cat4500 running ...

Hi, i reset my cisco 800 router manually and after that it unable to display all text key in from keyboard. for example, i keyin login name cisco, it only can display ''c'' only. How to solve it?

Hello All, In Nexus, if we poll for ifspeed, it gives the speed configured on the interface.  For example, say the interface supports both gig or 10G. How can I just extract the highest it can support though I have manually/Auto nego to a Gig? Pleas...

Hi All, I'm having a strange issue setting up a 887 when I'm trying to set it up for ssh access. starting from an erase startup and reload I enter the following commands  Router#conf t Router(config)#hostname test-rtr test-rtr(config)#ip domain-name...

I'd like to know where i can find something to read about CLI Template - syntax of all commands, operators, variables and so on. For example, i need to implement some config only on device's interfaces, that have specific description or something els...

Hey all, this will be my first foray into configuring a Cisco switch, and I have some issues I want to get addressed before even attempting to do this.  Basically, we have a "special" network setup that's restricting our number of available IP addres...

Hi, All I want to adopt EEM as workaround for a resilient hash function of ITD. It was working fine in case under 16 nodes down but it wasn't working properly over 16 nodes down. I guess it is caused by vty session limit. So I already add "end" comma...