Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello, since the asa supports pbr we want to use this feature to do some traffic shaping. We are running version 9.5(1) and have two ISP connections via PPPoE each ISP. Is it possible to use pbr on the asa in this scenario? We have done the setup wit...

escswosp by Frequent Visitor
  • 1041 Views
  • 2 replies
  • 0 Helpful votes

Hi, I have a query regarding a single transparent firewall being deployed as ISP terminating firewall in a network design, now I want to use another ISP for redundancy and want to terminate on the same firewall. I know that Route tracking(IP SLA) and...

risarora by Cisco Employee
  • 404 Views
  • 1 replies
  • 0 Helpful votes

Hi I have asked for advice before on these forums and you have been extremely good and very helpful with your guidance. We have a Single Cisco ASA 5510 firewall live in our production network at the perimeter. This currently has a large amount of c...

I'm trying to forward port 4520 on my local IP Camera. I have only two interfaces inside and outside with security levels 100 and 0. I have already done nat overload. In Access rules I have such situation :  and in NAT : but when I'm trying to ...

n.kiskeidze by Community Member
  • 2944 Views
  • 15 replies
  • 0 Helpful votes

Wanted to make sure I had my syntax right for this.  I'm trying to forward a port say 8030 from my outside interface to a host on the inside on 3389. Here's what I have so far object network 1.1.1.1  host 1.1.1.1  nat (inside,outside) static interfa...

Does anyone know why this log message is generated: Error Message %ASA-5-502103: User priv level changed: Uname:  user From:  privilege_level To: privilege_level In my case the Uname: enable_1 is not a recognized username local to the FW, is this g...

agoraya by Visitor
  • 1668 Views
  • 1 replies
  • 0 Helpful votes

Hi,Firepower 8000 series sensor deployed inline mode and i want capture spesific ip address from sensor, i got answer from support they say it is not possible.for example ip address: 1.1.1.1src: 1.1.1.1 dst any and connection logging enabled.traffic ...

zaferberber by Frequent Visitor
  • 3122 Views
  • 2 replies
  • 0 Helpful votes

Wouldnt this ACL bring down the network? Since internal-out ACL has deny any any at the end implicitly, this will allow only icmp going out? ciscoasa#config t ciscoasa(config)#access-list internal-out permit icmp any any echo-reply ciscoasa(config)...

Review Cisco Networking for a $25 gift card