Network Security

Hi Team, I am planning to conduct a health check on our Firepower IPS. Could you please help me guys on how to do this and what are the necessary information that I need to check or gather on our IPS.  Thank you very much! Regards, Mady

I followed this process Install and Configure a FirePOWER Services Module on an ASA Platform on a 5512-X with CX module and it all works until I get to the "sw-module module sfr recover boot".  I get "Storage device not found.  Install drive and try ...

Hello, What is the CLI (or ASDM) config on version 8.2(5) to configure the NAT bellow (it is in the version 9.1(6))? nat (outside,outside) source static OBJ-10.30.100.3 OBJ-10.1.252.10 destination static OBJ-10.200.200.219 OBJ-172.31.18.219 The flow...

Hello experts, I want to install SSL certificate in Cisco ASA firewall. I don't have ASDM access to the FW, I have only CLI. Can you please guide me how to do that? I generated the CSR from the ASA using the below command: ciscoasa(config)#crypto ca ...

Hi All, I have defaulted a 5510 to factory settings but the device will not boot now. It loads the image and states that its a ASA5510, then moves to dosfsck but does not progress from there. It does not move past this after 30mins. This is taking t...

Hello, How does the user-agent work on the firepower/5506-x? Is it only for monitor and reporting or can you use it to create filters applied to users? martin

Hi,1- Can we deploy URL filtering for network zone that the client doesn't joined to domain control? by make policy on subnet?2- can we block Facebook all pages and permit only specif pages? Thanks.  

When I view my Sourcefire 3D7030 Sensors in the Defense Center running v5.2 I am receiving a Health Policy Error stating:"Error Modules:1,Normal Modules:8,Disabled Modules:17 Module Traffic Status: Test Failed"Does anyone know why and how to fix this...

In Sourcefire Defense Center running v5.2, if you navigate to the Objects -> Security Zones tab, I receive an error stating "loadObject: No UUID Provided" when I click on one of the existing security zones . How do I fix this problem?Thanks

Hi team, pls help me in trouble shooting the below issue. We are having ASA 5555 with software ips module.Requirement is to access the ips module through telnet/ssh by using putty. But we are unable to achieve the requirement. We can access ips modul...

Hello Experts,  Would like to know, Why this is not advisable to connect Firewall with other Firewall directly for data communication, Rgds

I'm wondering if what I'm trying to do is even possible. I have a Cisco 3750G switch. I issued "no switchport" on one port on my switch so that I could assign an ACL to that port on outbound traffic. Before, I had it joined to one of my vlans, but I ...