Network Security

I believe the command "clear config threat-detection" will  disable all the thread detection on the firewallIf it diables how do i enable the threat detection agaian-Nimika

Hello guys,I have Cisco ISE installed on EXSi in a lab. I was able to join the ISE server to my test Active Directory server, and under the OU=Computers, I can see my ISE hostname.However, when I go to Administrator > External Identity Sources > Acti...

How do i free memory on cisco asa 5510 below is the details of memory allocationsResult of the command: "show mem detail"Free memory:                      54483928 bytes (20%)Used memory:     Allocated memory in use:    128787496 bytes (48%)     Rese...

I have setup the NAT to run site-to-site IPsec tunnel, but it seem my NAT is not working properly. Would you give me some help on troubleshoot this please. I could not find any hits on my NAT. Thank youshow run: Saved:ASA Version 8.2(1) !hostname xxx...

We have cisco ASA 5510  and constantly after a month or so we are getting memory allocation error and user is not able to loginto vpn.I tried to clear cache and log buffer but the mem usage is not comming down. How do i find what is using the memory?...

Hi,I have a Question, we have two datacenter,  each of one  have two ASA 5585 in cluster mode with multicontext, is posible configuring  failover active/passive with context between the datacenter.I would like to have some context active in one site ...

Chaps,I have two data centres in HA mode - one active and one standby - if the active was to go offline due to a failure we would like the standby DC to take over as the active DC for the period of failure. Now to do this we need to keep everything i...

Hi Experts,I have some confusion with IPS(intrusion prevention system) so plz provide suggestion on given below queries:1. what would be the IPS placement as per your opinion ( is it placed before Firewall or after Firewall) ?     Router------>Firewa...

We currently use LDAP (mapped to a specific AD group) for admin access to our ASA's.  I have one ASA that I would like to grant readonly access to a single user but I am having a hard time figuring out how to do that.  ASDM/SSH access is via LDAP, so...

Hello,I have an issue of high memory usage in my ASA5540 (85%).in attached the result of the command (Show memory detail)I suspect that the issue is caused by 65536.Below the result of the command "show memory binsize 65536"I think the issue is cause...

Hi folksIs it possible to poll the following number (in bold) using SNMP?I dont know where to start in order to figure it out for myself :-/OD-FWSM1/act# sh np 3 acl count 0-------------- CLS Rule Current Counts --------------CLS Filter Rule Count   ...