Network Security

Hello,we have an ASA cluster providing RA VPN for users.I have an address pool configured like this,The problem is that sometimes the ASA will give address for the users not from the first addressr but from the middle of the pool.Is this a bug?Thank ...

We're trying to get a remote access setup for someone who needs to have access from offsite. To make things easy we set it up with a virtual machine running Windows 7 and RDP. Because the "other end" isn't our computer and we've had some difficulties...

I got a Pix 506E from work that we have stopped using. I want to configure it for my home network to learn more about the device and use it as my border device.I have pppoe internet that I read this will handle. I've looked around the site, and check...

Hello Guys.good Morning....I need help and i have few questions for configuring my IDSM and also IPS Appliance.As you know cisco 6500 does not support more than 2 session of SPAN, so this option i do not have to configure for IDSM. both these session...

Hi,Currently, we should be receiving updates for our Cisco ASA 5505 device for software updates and IPS signatures using the Cisco Notification Service.  However, we have yet to receive any email through our configured account. Is there a specific re...

I have no console access and no mgnt port access... trying to get into a spare box we have ... I turn it on , and I have no access ??? Is there a special or different DB9 cable I need??? Is it possible the console and mgnt ports have been configured ...

How do I configure my IME to send email notifications on a port other than 25? Specifically, I need to talk to my email server on TCP port 993. Any assistance would be greatly appreciated.

I am trying to setup my very first ASA5505 and I cannot get it to pass traffic from the inside to the outside. I am not using NAT/PAT. Here is what I have done so far.ASA5505(config)# interface Vlan 1ASA5505(config-if)# nameif insideASA5505(config-if...

HiI have to connected the lan failover interface with a crossover cable. When I enter "show failover statistics" on both ASA 5510 I get VersionsCisco Adaptive Security Appliance Software Version 8.4(2)Device Manager Version 6.4(5)206PrimaryFW-DC01D/a...

Hi,We have ASA running code 8.0.4 with Active/Standby for quite long time. Today when we gave the command wri standby it started sync the config to standby ASA but waited forever.when we checked the show failover, we got the following result. This ho...

We have an ASA 5540 running 8.4(1) on the inside of dual Internet-facing border routers. The routers run BGP facing out and EIGRP facing in, with the ASA also running EIGRP for the same AS. Both routers redistribute a default route into EIGRP. It was...

HI can anyone tell me what ports need to be allowed to allow video confrencing through the ASA can i use nat instead of access lists to do the same

I have a new 5505 installed to a pretty small network.  I have the outside IP/mask/gateway from the provider, and I can see the other end or that connection as well as ping devices out on the internet from the console.What's a good rule of thumb for ...

Hello all. I have a ASA 5510 Firewall with the IPS Module installed. For reasons I am not aware of I am unable to access the IPS Module from the ASDM software. I have reset the password to defaults but am still unable to get access to the IPS. I get ...

I have to run the "recover application-partition" on some IPS/IDS devices we have after a botched upgrade.  I have successfully completed this on a Cisco 4260 Sensor and all went well.. the remaining devices are IDSM-2 cards in 6509's.. my question i...