Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi,I wonder how to enable a scenario where i have to use  two ISP's to share 30/70 load on our internet traffic, have to configure almost 60 internal websites already published using microsoft TMG firewall and connect client VPN connections and site-...

saulatsaleem by Community Member
  • 1294 Views
  • 1 replies
  • 0 Helpful votes

Hi.I have a problem with failover. On My site I have 2 Firewalls 5580. And I did this configuration on my firewall.interface GigabitEthernet3/0description LAN/STATE Failover Interfacespeed nonegotiatefailoverfailover lan unit secondaryfailover lan in...

d_steffen by Community Member
  • 1149 Views
  • 1 replies
  • 0 Helpful votes

I would like to setup a small home network with an ASA firewall and an 871 router for testing purpose so I can get familar with the ASA commands and concepts.  Is there sample config I can be pointed to?

Hii have thought many times about outside Nat but i m confused when will be such situation that we will require outside NAT.Can anybody give me best example of real Network, and explain me the traffic flow i have read in book but still it is not clea...

I have three interfaces configured, outside, inside and dhcp.  The IP for the inside is 10.10.220.101 and dhcp is 10.10.230.1, with same−security−traffic permit intra−interface configured but still not able to communicate between interfaces.  The err...

Hi all :I think the ASA5505 I have is in basic license. When I open the third interacse : dmz it must activate No Forward command then can work.Any way to resolve this problem? is it must pay money to buy the license so that can work without No Forwa...

I'd like to monitor the state of Bypass mode for the ASA-SSC-AIP-5 and would like to know if I can check this with SNMP and if so, which OID.I started messing with SNMP and the SSC5 a while back and started a thread about snmpwalk causing it to crash...

Mark^ by Level 4
  • 2206 Views
  • 9 replies
  • 0 Helpful votes

Hi all,  I have this issue, I save the configuration in the ASA 5505 using write memory or using copy run start but whe i unplug the power cord and plug it back in the ASA gets its factory default configuration.... then what i do is a copy start run ...

adavila03 by Level 2
  • 5339 Views
  • 2 replies
  • 0 Helpful votes