Network Security

can someone out there enlighten me on which cisco firewall is suitable for me to use ?

I have 4 subinterfaces on my ASA (as of right now) and was wondering how many I could actually put on ONE interface, without seeing traffic slowdown?Anybody know?

Is there any documentation as to best practice or how to go about configuring ASA's for multisite VPN failover from a MPLS network failure?Thanks

I have a basic IPSec tunnel between a 1841 (site a) and a non-cisco (site b) router. All appears okay but the only way I can ping site b from the 1841 is to source the private interface. How can I make is so this is permanent? I would like syslog and...

Can Cisco2821 and Cisco2811 routers support Stateful Packet Inspection. If yes, how to configure it? If No, kindly provide supporting documents/links etc.Thanks and Regards,Ashish

Dear All, I have got ASA 5510 with 7.0 Version. i created a IPSEC site to site vpn, when i ping, i can see IKE tunnel 1 on asdm n then i get an error of QM FSM.... I have done the configuration through ASDM only.How can i define these strings as this...

Can i change the enable password from ASDM as i dont have the old password or i have to go through the Rommom mode.

Hi everyone, I would like to ask you is it possible to inspect HTTPS traffic?I need this becouse I'm trying to deny skype traffic over port 443.Thanks!

while i am adding Users , page is not submitted and the Html page refresh withthe new port number, ihave the local host added to Intranet Sites and not in Trusted sites,is this an issue to do anything with Page submission

I apear to have locked myself out of a FWSM contect.. When I connect from the FWSM itself with changeto context <NAME> If get the <NAME># prompt, but if I try conf t from here I getFallback authorization. Username 'enable_15' not in LOCAL databaseI w...

Hi,What is the difference b/w PIX & ASA?

I cleared the configuration on my ASA 5510 with "write erase" and "reload". I then typed "config term", "no pager" and "end" to turn of "---More---". Then typed "show tech-support". The screen started scrolling as if I had type "show ?" over and over...

I am unable to send email traffic from a web app on a server on my DMZ(Pix 525) to my exchange server on my inside interface. It works fine when the email traffic comes from the same app on the inside interface. I have allowed traffic from the dmz se...