Network Security

Hi,Whenever we apply the signature update to IPS 4240, it reboot itself normal but gives an error after enter the username/pasword by using ssh; and not enter the CLI. "Error: Cannot communicate with mainApp (getVersion). Please contact your system a...

How can I configure DFM 2.0.4 to collect config from device when config changes, immidiatly?thanks!

We have pix 515E with FOS ver 7 .We would like to know how to ping the outside interface from a host on the insideThere is NO nat-control and even after we gave icmp permit any any on the outside interface and inside interface the inside hosts whose ...

I use my router itself as a DNS forwarder. Unfortunately when a domain query is requested on the LAN side, the packet is sourced with the ouside interface IP address which is ouside the EzVPN tunnel and thus the reply does not find it's way back. Can...

I'm having a heck of a time getting my 871W router to do a simple dhcp binding. I want to set up dhcp binding so I can use dhcp on the client machines, but always know the ip address so I can use monitoring software or web/ip connections to fixed add...

HiPix model: 515EOS Version: 6.3(3)Trying to connect through consule. System stuck after the following msg:CISCO SYSTEMS PIX FIREWALLEmbedded BIOS Version 4.3.207 01/02/02 16:12:22.73Compiled by morlee32 MB RAMPCI Device Table.Bus Dev Func VendID Dev...

Dear all,We are using NIDS - 4250 for the last 15 months.We are continuously monitoring its disk & memory usage. We found from starting the memory usage is increasing normally & gradually(1% in 40-50 days). But for the past two months we are finding ...

The ASA was configured and I was working remote through SSH and Telnet.Without any messages the ASA doesn?t respond any Telnet and SSH request, and I tried to go with ADSM tool and I got the following messages:"ADSM is unable to read the configuratio...

I can?t connect to console in a ASA 5540.I was working checking some configuration lines and I got disconnect and now it?s impossible to get into.is there any way to get console without reset the ASA ?

Hello Experts,If anyone can help me on this and provide some sample configuration will be great.note: We have not yet purchased a 877 but planning too do so...The pix has more than 5 ip add i.e.*.*.*.1 Outside*.*.*.2 webserver published*.*.*.3 SMTP p...

When a service-policy is attached to an interface, for example, a policy which defines an outbound QoS policy, is the global-service-policy still in effect, or does it need to be merged with a user-specified policy. In other words, does an interface-...

Hello,i'm using a pix 525 as a dhcp relay for 2 isc dhcpd servers. I enabled the "Set route" option in asdm for each vlan, but client continue to see the dhcpd servers. The pix doesn't rewrite the server filed in the dhcp reply. When the client tries...

Good morning I have upgrade the relase of my Pix Firewall, from 6.3 to 7.1(2)Now I need the feature floodguard, (which I had enable on 6.3) but I don't find the CLI to enable floodguard, anyone know the right command line to active it?I've read the l...