Network Security

I have a PIX 515 in Active\Passive failover on PIX 7.0(2). I have disabled monitoring of several interfaces with the "no monitor-interface" command as they are not in use. When checking failover on secondary firewall all interfaces are being monito...

I've read the 5500's do not support VPNs whilst in multiple context mode - Are there any workarounds for this?

I want to setup my PIX so I can VPN into the PIX and gain access to internal network resources. We have an odd set up as there are 3 interfaces on the PIX. Inside, Outside and VPN.We just added the VPN ethernet card to the pix.Right now, our inside...

I am trying to use the Auto Update Server to update my firewalls, but it is not working. When my pix 501 tries to get its updates I get the following error in the 501's log: Error 612003 Auto Update failed to contact: https://10.10.5.6/autoupdate/Au...

Good MorningCan Cisco tell me if signature S202 is out yet for v4.1 and v5 ? S201 was sent out on Nov 8th.Any update is appreciated.Regards,David

What is the CLI syntax to not include an IPS signature. Like I want to remove the 2001 sig from the built-in.sdf

Can anyone tell me if VMS 2.2 supports the management of IPS 4255 running 5 code, according to the documents it does not explicitely state that it does.

Hi,We are using PIX 7.0.4 and Our dhcp server was located on outside. I could configure the dhcp server address. However, I found that dhcprelay can be only enabled on physical interface but not vlan (tagged) interface.Is it PIX-OS bug ?Do this probl...

HiCan anyone confirm that the ASA can do network anti-virus scanning?If so what models do it and how much does the performance suffer?Darren

HiI have a 501 pix firewall with 10 user license. I have also 15 mail user. they r connecting exchange server in remote server.now if i installed Pix firewall and 11 user or avobe users want to connect same time then what happend ?. Pix not work for...

We have had a number of sources within our network trigger an event to notify the security analyst of the recently identified macromedia vulnerability The signature looks like thisSIGID: 5692 <protected> SubSig: 0 <protected> AlarmDelayTimer: ...

Dear all,when we trying to upgrade our pix software from 6.2(3) to 6.2(5) using monitor mode we are facing the following problem monitor> monitor> int 10: i8255X @ PCI(bus:0 dev:5 irq:12)1: i8255X @ PCI(bus:0 dev:3 irq:255)2: i8255X @ PCI(bus:0 dev...

I am unable to logon through PDM (pix 501)cos i have forgotten the password and the pwd recovery for pix doesn't work for the PDM. If i decide to erase my pix or set it to factory configuration, will that reset the PDM password. How do i erase everyt...