Network Security

I would like to know if it is possible to install Cisco Security Agent on my CallManager without haveing a Managenent Center.If yes, what are the principal differencies with the utilisation of a Management Center ?Thank you for your help.

Is it possible to use a TACACS server(ACS 3.3 in our case) to authenticate IDS admin users? I can't seem to find this anywhere in the documentation. Thanks.

Hi,In order to allow Users to save their VPN-Password in the Connection profile of VPN Client, an Attribute called "SaveUserPassword" must be set to "1".But this setting is reset every time i connect to our central PIX 515. How can I tell the PIX to ...

Our existing restricted license PIX devices do not seem to be utilizing the VAC+ cards that we recently installed in 3 PIX 515s. From what I've read, it should just work. Here is output from two of the devices:Cisco PIX Firewall Version 6.3(3)Cisco P...

Hi, I have just acquired a Pix 501 with 10 user licences and i do not have any knowledge in configuration of firewall. My existing network consists of a Aztech Router cum ADSL modem and a Cisco 2900 switch. I am using dynamic IP address form my ISP f...

I like to block ip range for 64.68.96.0 with 64.68.127.255 as subnet mask at PIX 520.conduit deny tcp host 64.68.96.0 subnet mask 64.68.127.255 0 0I don't want to use any access list.

What ports need to be open for SecMon to retrieve alerts from a sensor? Is there more than SSH and 443?Thanks

I have a number of spoke sites connecting to a central hub site. All sites are using ISRs (2801s no PIXs). I want all internet access to be via the central hub site (no split tunneling). I know that this would have been a problem with a pix at the hu...

I'm having problems performing an FTP update command on 4.1.4. I've tried all the various combinations of passive mode, etc.Has anyone seen the IDS not be able to pull updates in passive mode? Here is the FTP server log of the session:Wed Mar 2 01:41...

I have seen the information for IPS Version 5.0. How long will you continue to support version 4.x?

Hello,I want to monitor 2 vlans (Pix inside and Outside) with TCP Reset on the same switch 2950 and i have only one sensing interface on my sensor 4210 !Is it possible to do that ?Many thanks.

Hi.I am new to PIX and am having some setup issues.I have just purchased a PIX 501 - unlimited license. My internal network is currently configured using static IP's using 192.168.12.XXX with a 255.255.255.0 subnet.I want to replace my current firewa...

PIX 515 6.3on my inside interface:192.168.1.1 is Cisco VPN hardware client192.168.1.2 is inside interface addresstrying to route 10.20.14.x address thru 192.168.1.1 and any other requests like internet access thru 192.168.1.2commands used:route insid...