Network Security

I am trying to upgrade my PIX515 to 6.3(3). After following the procedure to tftp in monitor mode with different machines and different tftp servers. I see the image transfer then a message is seen on the console stating that the checksum verificatio...

Hi,I have a PIX 506 with a 3DES tunnel to a PIX 501. I would like VoIP traffic to tunnel without encryption or at least less encryption.I was thinking about using tunnel interfaces(i've created 'int tunnel 0' on 2600/1700 routers in the past) because...

I am trying to import a configuration into VMS 2.2. I am sure that all the passwords are correct and that all the IPs are correct. Is there a particular step(s) that I am omitting? Are there correct ways to actually discover your PIX in VMS IDSMC?Tha...

I am looking for an easy way to measure utilization on a site to site vpn configured on a 3005 concentrator. Help?

we have several sets of PIX 515 firewalls running in failover mode on our network. All are running version 6.3(1). The problem we are having is when we issue a command, such as "show run" that brings us to the "<------More------>" prompt. If we do no...

Hellodoes the Pix firewall support file based (manual) enrollment with a certification authority ? I looked up in the documentation and I found nothing about it.Thank you in advance.

Hi,I have configured syslog server on Pix.Logging onLogging host inside a.b.c.dBut I don't know where to check logs on the Host a.b.c.d.It's windows 2000 server.does I need to do any config and setting on Windows a.b.c.d server ??Thankx

Hello, I have an old Pix with 2 MB of Flash, only able to run Pix IOS 5.1.5 I have a single static IP address on my home broadband connection. The PIX wont perform PAT on the single outside address. Here is the snippet:ip address outside 63.XXX.XXX.1...

We need to migrate from CSPM to VMS FW MC (since CSPM will not be supported anymore soon);As we have hundreds of networks and services objects names in CSPM and samething for the access rules, it would be nice if they can be converted in a format acc...

Hi..How can I ping a PIX internal interface from another network? Actually I can ping the PIX Internal Interface from the same network that .e.g (mask 255.255.0.0)Pix Int. Interface: 10.100.5.12My Ip : 10.100.0.75But at my PIX firewall I have another...

I am under the assumption that QoS is an IP layer 3 service that would not apply to a layer 2 type device. However, I have seen references to QoS using a bridge. Is this possible?Thanks,Diego

Hi, I use VPN client 4.01 to PIX 515EOn remote computer, I manage to set up the vpn and work with it using RTC dialup connection.On the same computer, when I use a DSL connection, nothing works. I can conenct the VPN but I'm unable to ping or tracero...