Network Security

i'm replacing a PIX 520 with 3 10/100 interfaces, and 1K user license. thw PIX si 5 years old an i need to put in a new one. what would be the best replacement PIX?

lanA<-->pixA<-->router<-->routerB<-->lanB router<-->routerC<-->lanCi was using static command on the pix.static (inside,outside) lanB lanA netmask 255.255.255.0static (inside,outside) lanC lanA netmask 255.255.255.0i know that the above commands are ...

I have the responsibility for providing Internet access, through our network, to agencies and individuals from outside our organization. What I would like to do is policy route their traffic so that they can only get to the Internet, but nothing inte...

We have a Pix 20 (v.6.2(2)). We are trying to configure the pix so that it can pass Windows 2000 authentication (Kerberos) to the inside network from the DMZ. What is the correct and saftest way to do so.Thanks in advance,Tou

I have established an IPSEC tunnel with two Cisco 2621 routers. Clients over the Internet are able to dial into the MCU server, which is behind one of the Cisco 2621 routers configured with NAT but the MCU is not able to call the client. The MCU is a...

Is there any way to get a time stamp for each log entry? It shows all the other important info for each entry, but does not stamp the time.ThanksJeff

I am trying to add an Access Rule to allow a subnet 10.0.2.0/24 to access outside network from my inside. The inside interface address is 10.0.2.1/16. When I try this thru PDM, it does not accept a class C mask in the rule (10.0.2.0/24), but only acc...

I'm reading a book about PIX, and it claims that PIX protects layer 2-7. I can only find info on how it protects layers 3,4,& 7. Do any of you experts know any specifics about how it protects each layer? Here's what I have so far...Application layer:...

I am monitoring the logs from a CISCO PIX 506E firewall (6.3.1)on RME 3.4 VMS. I see the logs only on the Unespected device report, when I try to get a Severity summary report from that device I can not. In the RME documentation I found that the sysl...

Hi there, One of my client would like to know wether the QoS Policy Manager 3.1 can check the port status, utilization,throughput and performance of the switch? And if it is feasible, may I ask the way how to achieve it?many thanksDavid

I have a connection to the MBone on the outside interface of my PIX. I have a PIM router on the inside. I have the igmp helper address command on all internal interfaces pointing to the inside interface of the pix. When I do a show route, all the mul...

My problem is as follows: I have a PIX 535 that has Inside/Outside Interfaces. The Inside is my network and the outside is a 3rd party vendor's network. The inside has a router the outside does not. The servers on the outside point to the PIX outside...

Can somebody say how to know the bandwidth utilized by the site to site vpn pleaseTksTHomas