Network Security

Hi,I would like to know whether we will be able to configure IP directed broadcst, or helper address in PIX. The scenario is something like this.There are two networks connected through internet. At one location we have PIX 515 (PIx version 6.2) an...

Given that I am configuring PQ/CBWFQ over MPLS and using rate limiting to mark the packet on input. On congestion does the packet go thru three different software modules ie the policy first, if policy is oversubscribed then second, the fair queueing...

hi all,anyone know the command to get the PIX to block directed-broadcasts from the outside interface?or is it for the router todo?cheersdave

using CISCO-PING-MIB in MPLS VPN ? In CISCO-PING-MIB.my document, wu can use the CISCO-PING-MIB to Proxy ping the hosts in the MPLS VPN (vrf). But when i do it, router will return the message: errstat =12; errindex = 1(ciscoPingProtocol). If Router i...

My english isn´t good , but a hope that understandmeAny body speak spanish??I am installing a PIX 515 with 3 interface fastethernet ( e0, e1 and intf2). I have two ISP to internet. One interface (e0) is conected to cisco 2621 ( ISP telecom). Another ...

What is the difference in software and hardware between buying two independent PIX or two PIX with failover?Regards.

Is it possible to do a lan to lan vpn (ipsec) from a pix 501 using a dynamic ip address on the outside interface. To a cisco 3030 concentrator.

Hi,maybe this has been rasied previously. After modifying the crypto settings on an existing IPSEC tunnel (like removing a crypto peer and adding a new one), the Ethernet interfaces just freeze, and only the console responds, and the PIX should be re...

I need to change license key with new added feature support. How can i Change license key on PIX 515 running version 6.2(2)Thanks

I am having trouble syncing an external time server to our VPN Concentrator running image vpn3000-3.6.1.Rel-k9.bin.The time server is 140.142.16.34 (bigben.cac.washington.edu). We also seem to be having a DNS resolution problem as well, but one prob...

According to Cisco the Pix 501 has 10M throughput for clear text. I have purchased a 501 with 3DES license bundled together. I'm not using any encryption but I only seem to get 1.5M throughput as if I were using 3DES. Is there any way I can change...

I set up a PPTP connection. I can connect with out any problem but I cannot browse the network. Here is my configuration: PIX Version 6.2(2) nameif ethernet0 outside security0 nameif ethernet1 inside security100 enable password **moderator edit** enc...

Hello,DECNet will soon have to traverse my firewall.Any issues and things to look out for.