Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
Hi,I am trying to set up a VPN connection from a PIX 501 to a Linux FreeS/WAN using IPSEC and 3DES (another consultant handles the Linux-server).From the Linux-side, they can export their public key and send it too me.My question is if I manually can...
there is a command for split tunneling for the IPSEC clients... but what about PPTP? can you do it? Or is the only option to uncheck "use default gateway on remote network" on the client..Thanks!
I have one PIX515 with two interfaces. In the inside interface is my Primary Domain Controller PDC with windows 2000 advanced server and in the outside interface are all my users running windows 2000. I have openened all the necesary ports in the PIX...
Hello,I have a exchange 5.5 server behind the PIX 501 and would like to open port 110 and 25 on the PIX and have the pix redirect traffic to the exchange server on private IP 192.168.0.222How do you achieve this? If anyone have done this before, can...
Hello,everyone: How can I distinguish the Unrestricted license (UR) and restricted license software? Is there any command to distinguish them? Another question is what is PIX-VPN-DES (56-bit DES IPSec software license for PIX)? Is it a piece o...
I need to find out if subinterfaces are supported on the PIX firewalls. I am about to create a subinterface on my router due to non condiguous Class C IP ranges (can not do VLSM) and need to find out how the PIX will look at the different IP address...
I have two PIX 515 to be connected in a failover configuration. I want to configure "stateful" failover which requires a dedicated fastethernet interface on each PIX. Do I still need to connect the special serial failover cable between the two PIX or...
I have a PPTP client sitting behind a PIX firewall attempting to connect to a remote Microsoft PPTP VPN server. It appears to reach the remote server then returns a server not responding message during the authentication. I configured a static NAT ad...
Installed VPN 3.5.1 on a laptop running W2K, when I tried to connect to the PIX it displayed the following message "Remote peer is no longer responding" however it worked on a home PC running W2K and also on WIN 98 laptop/desktop.The problem seem to ...
What do you have to add on the PIX so that clients can access the outside (internet) when the clients are only setup for IPSec so that clients on the Outside interface can access them using the VPN client? Does anyone have any ideas - ?
