Unified Computing System Discussions

We need to integrate our Cisco UCS/CIMC with HPE Aruba ClearPass TACACS+ for centralized authentication.UCS Model:      BE7H-M5-K9CIMC Version: C240M5.4.3.2bCould someone please share the required CIMC configuration, TACAS parameters/attributes, and ...

We have the following connectedFabric Interconnect 6536 (UCS-FI-6536), 5108 Chassis with 2x IOM 2408 (UCS-IOM-2408 V03).We've cabled them with 100G QSFP28 to 4x25G SFP28 AOC 5M (NWP-QF-100G-S4-AOC-05-C)We've configured port as server port on initial ...

Need to replace a CPU on a UCS C240 M4 server as per https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/hw/C240M4/install/C240M4/replace.html#45480. However, the CPU that was delivered doesn't have the CPU plastic frame. So I'm not able to...

I am installing cisco virtual connected appliance using vcenter client hosted on esxi host. I followed the installation steps from cisco (https://www.cisco.com/c/en/us/td/docs/unified_computing/Intersight/b_Cisco_Intersight_Appliance_Getting_Started_...

Was encouraged to cross post over here...Hoping that someone can assist me in figuring out an mystery... I have proxmox 9.2.4 installed on an HX240c-M5 server and am trying to bring up the interfaces on the VIC1457.My initial install did not utilize ...

We have a minor warning on a Fabric Interconnect relate to disk space."Disk usage for partition bootflash on fabric interconnect A exceeded 70%"Fabric Interconnect APartition Size (MB) Usedbootflash 16329 82opt 3877 4spare 5744 6var_sysmgr 2000 16var...

Hello,We are a VMware shop but we are looking to dip our toes into XenServer since it is included in our licensing.  I've been searching around for a "best practices" guide for installing XenServer on UCS-X but not finding much.  Hoping someone can p...

We recently acquired 5x Cisco C220 M5's off eBay and connected them to our existing UCS cluster. They have identical hardware layouts and pretty similiar firmware levels, and are all connected to our FI's through identical Cisco cables. But, only one...

Hi All, I've a Cisco UCS200M8 Server with firmware: 6.0 (2.260044)Server was previously connected to a FI 6454, During that time the server failed discovery due to firmware incompatibilty.After disconnecting the server from the FI, i'm now trying to ...

Am i able to run ucs platform emulator on a vmware esxi version 7.0.3, just for test purposes and is it a good idea??

The ESXi OS on a node got corrupted. After reinstalling ESXi, I cannot re-add this node to the cluster and it throws a duplicate node error. Our HyperFlex version is 4.0(2f). I’ve attached screenshots of the whole process; could you advise how to rej...

Good day, Cisco Community.One of my clients would like to monitor the CPU and memory utilization of Cisco CIMC through SolarWinds. I have already configured SNMP and successfully added the CIMC to SolarWinds. However, no CPU or memory utilization dat...