Hello All,Device: ISR 4331I think NAT is what I'm looking for here. But, maybe someone could help me out with this.In a remote location we have an ISR4331 (*+ a C3650 Switch), which is connected back to HQ (*where I am located) on MPLS link via BGP. ...
Forum Posts
Resolved! Cisco 1921 configuration
Hi everyone, i have a Cisco 1921 Router as the gateway in my network to traffic my wifi network connected to a 2400 series router and a cisco switch, For some reason it will no longer connect to the default gateway and i can't ping it so i have no in...
Hi all, we are having trouble with VLAN tagging with 1G interfaces on ASR1004. Here the interface config: interface GigabitEthernet0/0/7.102 encapsulation dot1Q 137 ip address 2.32.99.81 255.255.255.252 When pinging the next hop it fails: Router...
Hi All,Please let me know is it possible configure Cisco Stack wise technology by connecting switches using Gigabit ethernet ports, i.e without stack wise cables.Thank you,
I would like to manage all of our hardware in our system including historians. However we struggle to find out the cisco versioning. How does cisco manages the versions of the hardware? We are only interested in major changes so would like to know mo...
Hello.Got a simple STP instance with 3 L2 switches in GNS3.Just Spanning tree priorities and VLAN 1 interfaces are configured: SW-01#sh run | i spanningspanning-tree mode rapid-pvstspanning-tree extend system-idspanning-tree vlan 1 priority 4096 SW-0...
I currently have two 2130 firewalls deployed in an active/standby deployment. I was thinking of some different ways that I could use both of them in an active/active way with some type of automatic failover. I was hoping to find a solution instead o...
Hi,I'm trying to run the following command and for some reason it will not work... It is on a Cisco ASA 9.9(1)(config)# copy startup-config tftp://192.168.1.24/GC_ASA_backup When I do that, I get this:%Error writing tftp://192.168.1.24/GC_ASA_backu...
Hello,Looking for confirmation to install additionnel uplink NM-8X with C9300-48T-A, and if i need to change my power supply 350WAC to 715 or 1100 ? RegardsFrederic
Hi: I have a strange problem with QoS. I have a QoS configuration in a Hub-and-spoke topology. When traffic begins to expand the VoIP calls are broken. But the strange thing is that bandwidth does not reach the bandwidth limit, and neither of the two...
Hello, I was hoping someone could help me with my virtual service container deployment. I have been able to activate the Ubuntu sample ova from cisco following the ISR/ASR developer FAQ. Problem is once the virtual service is activated I cannot get ...
What differences between WS-X6K-SUP2-2GE & WS-X6K-S2U-MSFC2
Hi guys. I have following schema:cisco router as DHCP server - vlan12 (guest wifi) <-> - dot11 0.70 - dot11 0 - bvi70- client cisco 881wclient got IP address 192.168.172.52 from server. DHCP lease expires in 1:41 PM (13:41)Current time 11:41:21++++++...
Hi Tech guys, I would like to confim the cisco campus logical design with core and distribution switches. we have STackwise virtual in between Distribution(9400) and Access swithes(9300). What could be the logical design in between Core to core an...
hello Everyone.during implementation of MC-speaking app in client's company, I have found some wireless MC&IGMP topics a little bit unclear. specifically my environment contains both local- & flexconnect-mode APs. some flexconnect-mode APs also centr...
