Hi , In one of the hub routers Cisco 3745 IOS c3745-i-mz.123-6a.bin the NM-2CE1B the timeslots line protocol stays up even though the remote branch wan link goes down ,as a result the routing thru ISDN PRI drops packets. The timeslot is admin shut t...
The problem is coming in a point to point LL between Cisco 3661 and 2610xm.The serial int of the branch router (2610xm, s 0/0) shows the status down for DCD and CTS, all other parameter up.The modem status shows loss in line but Telco checked the lin...
Hi,We have a cisco 1700 series and two 2500 series these routers connect our three branches using leased line. presently each branches have different subnet. eg. Branch1 - 192.168.0.0/255.255.255.240, Branch 2 - 192.168.0.32/255.255.255.240, Branch 3...
Hi allI'm planning to connect an 800 series router to a SDSL link in Australia and not sure if the 837 ADSL router is compatible with the SDSL or not? Thanks for your answer.
We are planning to have 3 different networks in one VLAN. Is that possible?Say for example: 192.168.1.0/24192.168.2.0/24192.168.3.0/24 Could we have all these networks classified in one VLAN?
Hi,We have a leased line and the circuit does not come up with PPP encap, if HDLC is set the line protocol shows UP but i am not able to ping the remote interface, upon debugging serial interface on the remote end, we got a message shomething like "a...
I will need to install two new 6408A (8-port GBIC) modules to my Cat6509. I think these modules are hot-swappable. Could anyone confirm this? I just want to make sure I don't need a downtime to do this.Thanks in advance.
hi!If my corporate network is using EIGRP and my branch office is using RIP, will there be any problem for these protocols to communicate with each other if we decide to link our brach office to our corporate network?Thks!
I have a simple test setup :<computer1>-<router1>-<router2>-<Hub>-<computer2> <SMC router>--<internet> (The SMC router is also connected to the hub)Both routers are 2501's running RIP V2. The routing tables look fine. I ca...
Hi all,I have question regarding my setup:I have R1 router running BGP and facing to the ISP, R2 and R3 routers are running OSPF and BGP to R1 in the inside network. Now, R4 router is connecting to R2 and R3 and running ospf.I don't want to run BGP ...
I am running per-destination load sharing over a WAN with static default routes and I have noticed that the first default route in my routing table consistantly gets 50% more traffic than the second equal cost route. Does anyone know why?
