Other Network Architecture Subjects

Hi Community   Can I run an vCM (virtual Central Manager) for the Waas on a ENCS? Documentation is not that clear on this topic...   Kind regards

I have a Question to the WS-C3750G-12S-E and the WS C2960G 24TC-L.can communicate this Switch with some Tranceiver CISCO GLC-SX-MM over optical?i can't find the WS-C3750G-12S-E on the list.https://www.cisco.com/c/dam/en/us/support/docs/interfaces-mod...

buenas tardes Comunidad solicito de su apoyo ; tengo una inquitud con respecto al comando Show mac-address -table en yn equipo NEXUs capa 2 para mostral todo los equipos que tengo conectados a la red que me arroje la IP MAC VLAN y Puerto al que estan...

Hello, I need to priority the traffic on my switch 3750. I did an service policy and an access group to do this: class-map match-all rdpmatch access-group 101!policy-map rdpclass rdpset ip dscp af41 access-list 101 permit tcp any any eq 3389access-li...

 Dear All, I am not sure if I am correct with my netflow question in this category. But I hope so.  I am running "nfsen" as netflow collector. I am collecting the netflow data from two cisco devices: this is a C2921 as Internet gateway and a WS-C6506...

I'm trying to decide which option is better to capture all the traffic inside vmware (vswitch), so far the solution will include a virtual machine per host which then it will forward all the traffic to an IP (example 1.1.1.1) on an isolated VLAN. The...

Hi,Recently I am working with RESTCONF on Postman.Today I was trying to send HTTP request via postman to IOS-XE-Tunnel using the below path: https://XXX:XXX/restconf/data/Cisco-IOS-XE-tunnel:tunnel Usually this should return the data within the conta...

I am in the process of connecting 2 switches together through a patch panel. Can I start with a straight-through cable half way and end up with a cross-over cable?Thanks

I am trying to setup a lab with XRv VMs. I downloaded the VMDK files, setup a dedicated ubuntu 12.04 server with KVM installed and followed the installation guide. When I boot the VM it starts the boot process until it gets to the following error mes...

We currently manage a fiber WAN loop with a Wireless backup loop with REP on the Fiber side and Routed network on the wireless failover. A vendor is insisting on being able to use QoS on the equipment placed in local networks off the WAN to manage ...

I have two T 1's coming into the office. Both Routers take on their own T. I have noticed that the SHOW INT on the 1720 Eth0 displays 1255410 input errors, 0 CRC, 0 frame, 5 overrun, 1254276 ignored 0 input packets with dribble condition detected 60...

Hi,   When trying to add this netflow config, I get an error on the last line "collect interface output":   Config: flow record MY-RECORD description MY Flow Record match routing vrf input match ipv4 tos match ipv4 protocol match ipv4 source address ...

So with the fun marking games Cisco plays we now have two lines of "9ks" one Catalyst and one Nexus...I mean really Cisco...   So I currently run 4500-x in the core and we need to replace these so the question is Cat or Nexus...Its a collapsed core, ...