I am having a 2600 seires router.When i telnet to this router and do some debug like Debug isdn q921 after issuing terminal monitor command, after few minutes the output vanishes and i have to telnet againg to see the output.Help neededEphraim Mani
Dear The Expert,Why I can visit to my website www.lippogeneral.com but I cannot ping it, it replied with "Request time out"Pixlgi(config)# access-list inbound_filter permit icmp any host 202.xxx.xxx.xxxany idea?please advise .. thanks a lot in advanc...
Dear all, I have a catalyst 6509 switch, with 2 720 sup-eng, when I boot the switch in the morning both the sup- engs come to the rommon mode, I need to allways boot then from the rommon mode after which the redundancy works fine between the sups- en...
Hi,I am currently working at a University that has multiple campuses, all using their own VLAN configuration with VTP.We are looking at putting in wireless networks using Bluesocket devices for authentication.The wireless APs need to have a layer 2 c...
I want to simulate an app running on Frame Relay and I have a frame relay switch simulated. Is there a way to somehow simulate the latency that would normally happen over a real Frame Relay connection due to physical layout? I basically want to inc...
I'm sure this is something very simple, but when I ssh to a 6509 from my Linux machine and do a sh tech, the output gets down almost to the end, but then requires me to hit return at least a dozen times for each additional page to display. I've trie...
Hi,We have two 4510 switches acting as a core in HSRP mode with other 4500 series access switches connecting to it.I have configured MST with two instances in my core switches and vlans mapped to them.Do a need to configure the same instances and vla...
Hi there,I have a slight problem which I hope you guys will be able to help me out with. I have a IGX8410 WAN Switch which we are trying to reconfigure to deal with our Leased Lines. They have not been used for some time and the guys that configured ...
i've Ciscoview 5.5 installed to manage a serie of devices (most of CAT6509, 3662, 3745, 2611, 2950)...well for the CAT65 core switch, we've flexwan module slotted in, but in the Ciscoview, it can't show the flexwan card properly, instead it show "Uns...
Hi,I have 3 routers running bgp, one in as 3 the other in as 4 and the las in as 2, 3 peers with 2 and 4 only, on router 3 I am make a agg add from routes coming from r4 with as-set, from the docs they said that the agg route should appers with (as f...
hi we are using 7246vxr , over cable internet , modem and pc get ip from our tftp server , but some of our modems's and computers's ip are locked by some reasens ,there is no data trafic between router and internet (no ping etc.) , when ı reset mode...
I am wondering about the argument that is being used regarding MLFR regarding serialization of large packets over one link and therefore the system looks to put the small delay sensitive packet on another link therefore QoS mechanisms are inherent. ...
