Other Network Architecture Subjects

hello,I am looking for a low-end Cisco router that is suitable for operating in a home network environment. I would like to be able to support at least 2 subnets with the router. Also, I would like to be able to use it hopefully to learn VPN config...

Having this two errors incrementing in frame relay network int the router

Hi Mr/Mrs,i started logging on the router but no logging that is display. It seem that the logging is not operated, please help me.logging onlogging trap debugginglogging monitor debugginglogging buffered debuggingRouter#sh logging Syslog logging: en...

is the snmp community case sensitive? Thanks

Our office recently obtained DSL service with Alltel, speed is great! We have Cisco 1700 and a wireless broadband router to share another internet connection with home office. I followed the instructions that Alltel sent out with the modem, but I'm...

Hi All,I was blocking the ICMP Traffic when i say access-list 105 deny icmp any any it blocks for all source and all destination ip's.When i say access-list 105 permit icmp any host 206.90.116.250 access-list 101 permit icmp host 206.90.116.250 anyac...

can you set up two cisco routers with ISDN cards back to back? Or do you need an ISDN simulator. If you can what are the cable pinouts?

Hi I am using 3661 Router. I am trying to go into the Confreg mode. I am using Windows 2000 pc when i press Ctrl+Break i am getting the following message. ******CPU Out of Range Interrupt*************** Access Address high=0*7, Low =0*76940fc0 pc=0*b...

We have install Ciscoworks LMS bundle software on windows. Fir initial starting discovery of network devices automatically ,what necessay configuration required on Ciscoworks LMS server? If possible list the steps for discovery. & How to check wheath...

We are installing at point to point T3 where the T3 will be one circuit. I have configured the T3 controller and the associated serial interface as shown below. I am using the default settings for everthing else.controller t3 1/0cablelenght 133interf...

My access point is avaiable in cisco view but not i RME. In Discovery Metrics is device type unknown. In campus manager is it unknown and unreachable

I just installed 2 Sup720s. After configuring the first Sup, during configuration of the 2nd Sup, the console locked up. Probably because of TACACS statements. I switched the console cable to the 1st Sup while it was locked up to see if that switc...

I am trying to add a 3rd IP range to a vlan, that already contains 2 ranges, on a 6509 switch. If anyone knows how this can be done I would appreciate it.Greg

Hello.I have one more Question for my never ending Problem.I have a configured Hub with ip nhrp and 5 Spokes The Management-Tunnel between Spokes and Hub are ok.But the Traffic always goes over the Hub and not between the Spokes.The IOS of the Router...

hello,I will increase a VPN connection over DSL up to 2Mbps symmetric.At the moment I use a Cisco831 IP-Plus 3DES. The VPN connection works over IPSec-3DES and a additional GRE tunnel. Can someone tell me the max. throughput over the ethernet interfa...