Other Network Architecture Subjects

Is it possible to configure an AS5300 so that a DialUp User can be directed and restricted to being passed thru to a specific VPN portal on another network?

I am having a problem that i cant figure out. I bought a NM-2FE2W Port adapter to put into my Cisco 3640 and I get the following errors. CAn anyone tell me why this card being a pain.Running ios 12.2.15 T12*Mar 1 00:00:06.739: %FECPM-1-INITFAIL: NM ...

My group leading setup 8 computers on one switch. 4 of the machines are on 192.168.10.* and the other 4 are on 192.168.30.*, They gave me a cisco 2600 router and want me to connect the two subnets.Here is what I have been thinking of tring to do plea...

I was in the process of updating IOS in 46 different Cisco 2500 series routers over FrameRelay and encountered the following problem in two of the routers. 1. I first set the default route in the remote router to the frame relay ip address of the loc...

hello,We have 2 sup engine (sup eng2/msfc2) on our 6500. I noticed that the configuration on the switch is being automatically synchronized between the sup engine, but the msfc config doesnt.we have done the configuration on the msfc by manualy dupli...

In a ftp servers environment when the servers are meant for users to access from external to download applications. Logically, a show interface s0/0 will show a input rate lower than an output rate. However I encountered an output rate lesser than th...

We should expand our Cat 4006 with a 10/100/1000 RJ45 module. Is the new module WS-X4548-GB-RJ45 (Catalyst 4500 Enhanced 48-Port 10/100/1000 Base-T (RJ-45) supported on a Catalyst 4006 running CatOs 7.3(2) or we have to use the older WS-X4448-GB-RJ45...

I have one cisco 3640 Router connected to a T1 line and the ip address range is x.x.x.x/24. I got another router and one T1 line connected with a ip address range of y.y.y.y/24. I wanted to move my network from x-->Y network. I moved the my websites ...

Hi dears i m using cisco 2522 series router and 1912 series switches would any body pls like to guide me that how can i create VMPS server, so that my Vlans will be assigned autimatically to ports.

Is there any documentation on the errors that a catalyst switch keeps a count on. Like what is an "Alignment Error" and what is probably the cause of them.

We are designing a network with a couple of cat-6506 with MSFC's in the core and four stackable Cat-2980 in the closets. The first Cat-2980 switch in the stack is fiber uplinked to one of the core switches and the last Cat-2980 switch in the stack is...

Hello, I try to use ACLM but the status of AclmServer is Running with a busy flag set. When I run Edit ACLs in ACL Manager, the message "Cannot connect to ACLM server" appears to me. The version of ACLM is 1.6, CCS 2.2 with SP2, CM 3.3, DFM 1.2, RME ...

When you create an extended access-list; and you try to apply it to same interface in both in and out. This access-list will filter the traffic in both ways ?

I have layer 3 switching enabled on a 4507. I am trying to policy route using the default next hop command. When it does not find a match in the routing table, it seems to drop the packet and "debug ip policy" shows that it is not performing policy...